User manual WHIRLPOOL AWL 635 INSTRUCTION FOR USE

[. . . ] • Do not use extension leads or multiple adaptors. • Before any maintenance on the dryer disconnect it from the mains supply. • Do not operate the dryer if it has been damaged during transport. Contact one of our After-Sales Service technicians. [. . . ] dry iron dry and cupboard dry loads together. Start with the iron dry programme/drying time setting, remove the laundry to be ironed at the end of that cycle and dry the remainder of the load on the cupboard dry setting. The dryer is built from reusable materials. The dryer must be disposed of in compliance with local waste disposal regulations. • Before scrapping, cut off the power cable so that the dryer cannot be connected to the mains. Child safety: Children must not be allowed to play with the dryer. • This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: EC Declaration of Conformity • 73/23/EEC Low Voltage Directive • 89/336/EEC EMC Directive • 93/68/EEC CE Marking Directive. • The dryer must only be used in the household for the prescribed uses. • Always set the programme/time selector knob to • • • • 14 5. General recommendations: the “0” position after use. This prevents the dryer from being switched on accidentally. Before cleaning or carrying out maintenance, switch off the dryer and disconnect it from the mains supply. To clean the outside of the dryer, use a neutral detergent and a damp cloth. Wipe away lint from the door seal and the door using a damp cloth. DESCRIPTION OF THE DRYER A. Work top. B1. Water Container bottom version or B2. Water Container top version. Door: To open the door: pull the handle. To close the door: push gently until closed. Heat exchanger. A B2 C F D G H B1 E Reminder - Maintenance and Cleaning Clean the lint filter at the end of every drying cycle. Open the door Pull the filter upwards Open the filter Remove lint using a soft brush or your fingertips Close the filter Push the filter back into place. Heat exchanger Clean the heat exchanger at least every 3 months (See "CONDENSER" chapter). Wipe away any lint/fluff from the door seal and interior using a damp cloth. 15 DRAINAGE SYSTEM For water container top only To avoid having to empty the water container at the end of each cycle, the condensation water can be drained away. Note: if the drain hose is not supplied, the optional accessory AMH 883 kit, available at your dealer, should be used. The connection for direct draining is at the rear of the dryer. Place an absorbent cloth underneath to collect water spillage. Remove the hose located at the lower rear part of the dryer and insert it in the nearby hole. Fix the hose (length: 1. 5 m) to the outlet connection. The height difference between the two drainage connections should not exceed 1m. [. . . ] • Has the Start/Pause button been pressed?Lint filter or water container indicator lamp light on: • Is the lint filter clean?• Is the water container correctly positioned?• Is the heat exchanger clean? After-Sales Service If, after carrying out the above checks the malfunction persists or appears again, turn the dryer off and call our After-Sales Service (refer to guarantee). [. . . ]