User manual WHIRLPOOL AWM 008 - D INSTRUCTION FOR USE

[. . . ] GB QUICK REFERENCE GUIDE BEFORE USING THE APPLIANCE FOR THE FIRST TIME: • • • IMPORTANT: MAKE SURE YOU HAVE READ THE “INSTALLATION INSTRUCTIONS” REMOVE THE TRANSIT BOLTS BEFORE USING THE MACHINE FOR THE FIRST TIME First wash cycle without laundry: 1. Pour a little detergent (about 100 ml) into the detergent compartment . Select a short wash programme (see programme chart). This will remove any water remaining in the machine from the manufacturer’s test run. ROUTINE WASHES: Open the tap(s). [. . . ] When the pump is blocked by an object (buttons, coins, safety pins). When the appliance does not drain or spin properly. Important: Before draining, make sure that the water has cooled. REMOVING THE FILTER 1. Switch off the appliance (press the “ON/OFF” button). Open the filter cover with the coloured insert from the detergent drawer. Slowly turn the filter anticlockwise until its handle is vertical without unscrewing it completely. Now unscrew the filter completely and remove it. Remove any foreign material from the filter. Insert the filter and screw it in clockwise until it locks (until the grip is horizontal). Pour 1/2 litre of water into the detergent drawer to reactivate the Eco system. Some models have no filter, since they are fitted with a self-cleaning pump. Note: If the filter needs to be cleaned during a programme, reset the appliance by switching it off and then on again. DRAINING RESIDUAL WATER The residual water drain hose is located in the machine plinth. Lift the cover upwards with light pressure. Pull out the hose by about 15 cm (6 inches). Let the water drain into a flat container until the flow stops. Before a new programme start: pour 1 litre of water into the detergent drawer to reactivate the Eco System. If your washing machine is not provided with a drain hose in the plinth, to drain the residual water please follow the instructions given in the chapter “Removing the Filter”. WHEN TO DRAIN RESIDUAL WATER • • When transporting (moving) the machine. If there is danger of freezing in the installation room. In this case the machine should be drained after every wash. 30 CARE AND MAINTENANCE APPLIANCE EXTERIOR AND CONTROL PANEL • • Clean using normal household detergent (do not use abrasive products). Remove the filter from the washing machine with pliers and clean it. Replace the filter and screw the hose connection back on to the machine. Turn on the tap(s) and ensure that the connections are completely water-tight. [. . . ] The manufacturer declines all responsibility for injury to persons or pets and damage to property caused by disregarding the above instructions. The data concerning voltage, consumption and electrical protection are supplied on the inside of the appliance door. The mains connection cable may only be replaced by a qualified electrician. The appliance conforms to European safety regulations, EC directive 93/68 EWG and EN 60555. [. . . ]