User manual WHIRLPOOL AWM 022 INSTRUCTION FOR USE

[. . . ] GB QUICK REFERENCE GUIDE THE FIRST TIME THE APPLIANCE IS USED: • FOLLOW THE "INSTALLATION INSTRUCTIONS" • REMOVE THE TRANSIT BOLTS BEFORE USING THE APPLIANCE. • First wash cycle without laundry: 1. Pour a small amount of detergent (about 100 ml) into the detergent dispenser 4. Select a short program (see program chart). [. . . ] Set the programme selector to "0". After the desired time, reselect the programme. Hold down the "Start" button for about 1 second. TO STOP A PROGRAMME BEFORE THE END AND DRAIN To stop a programme before it has finished and drain the water: 1. Set the programme selector to "Drain". Hold down the "Start" button for about 1 second. The programme sequence indicator returns to its initial (leftmost) position. The water drains. REMOVING THE FILTER / DRAINING RESIDUAL WATER WHEN SHOULD I REMOVE THE FILTER? • • • Check the filter two or three times a year and clean it if necessary. Check the filter if the appliance is not draining properly or if it fails to perform spin cycles. Remove the filter if the pump is blocked by an object (buttons, coins, safety pins, etc. ). IMPORTANT: make sure the water has had time to cool before draining the appliance. REMOVING THE FILTER 1. Switch off the appliance (set the programme selector to "0". ) 2. Remove the coloured insert from the detergent dispenser and use it to open the filter cover. Turn the filter slowly anti-clockwise until the grip is vertical; do not extract filter as yet. Wait until all the water has drained out. Now unscrew the filter completely and extract it. Remove any foreign material from the filter. Make sure the pump impeller is not obstructed. Insert the filter and screw it fully down in a clockwise direction (until the grip is horizontal). Pour 0. 5 l of water into the detergent dispenser to reactivate the "Eco System". Select the programme and hold down the "Start" button about 1 second. WHEN SHOULD I DRAIN RESIDUAL WATER? • • Before transporting (moving) the machine. If the appliance is installed in a room subject to subzero temperatures. It is best in this case to drain the machine after every wash. DRAINING RESIDUAL WATER The residual water drain hose is accommodated in the appliance plinth. [. . . ] Secure the hose so that it cannot fall down while the appliance is running. DRAINING • 37 INSTALLATION INSTRUCTIONS ELECTRICAL CONNECTIONS • Electrical connections must be made in accordance with local regulations. • The appliance must be connected to the mains exclusively by means of a socket with an earth connection in accordance with established regulations. The manufacturer declines all liability for damage to property or injury to persons or animals deriving either directly or indirectly from failure to observe the above directions. • Voltage, power consumption and electrical protection data are supplied on the inside of the appliance door. [. . . ]