User manual WHIRLPOOL AWM 246/3 INSTRUCTION FOR USE

[. . . ] INSTALLATION INSTRUCTIONS MOBILITY WHEELS (for UK only) Depending on model, your washing machine is provided with mobility wheels. You will find these wheels in the accessory kit supplied with the machine, or you can order them from our After-Sales Service. 1 MOUNTING INSTRUCTIONS 1. Insert the wheels as close as possible to the screw (1). Adjust the front feet making sure that the machine is completely level with the floor. [. . . ] Reposition the inserts, fit in the drawer until it locks. DOOR SEAL • • Clean with a damp cloth when necessary. Check the seal folds for foreign bodies periodically. Remove the filter from the washing machine with pliers and clean it. Replace the filter and screw the hose connection back on to the machine. Turn on the tap(s) and ensure that the connections are completely water-tight. WATER HOSE MESH FILTER • Check and clean periodically 1. Refit the filter and screw the hose connection to the tap. APPLIANCE FILTER • Check the filter at least two or three times a year and clean if necessary (see “Removing the Filter”). CHILD SAFETY DEVICE To prevent improper use of the machine, turn the plastic screw on the inside of the appliance door with the thick, rounded edge of the coloured insert from the detergent dispenser or with a coin. Vertical Slot - Safety position: door cannot lock into place. Horizontal Slot - Normal position: door can be closed as before. 2 1 72 REMOVING THE FILTER / DRAINING RESIDUAL WATER WHEN TO REMOVE THE FILTER / DRAIN RESIDUAL WATER • • • Check and clean the filter at least 2 or 3 times a year. When the appliance does not drain or spin properly. When the pump is blocked by an object (buttons, coins, safety pins). Important: Before draining, make sure that the water has cooled. 2 REMOVING THE FILTER 1. Switch off the appliance (press the “ON/OFF” button). Open the filter cover with the coloured insert from the detergent drawer. Slowly turn the filter anticlockwise until its handle is vertical without unscrewing it completely. Stopping Rinse hold Press the Rinse hold button again; the load will be spun according to the selected programme. Lightly soiled/Half load button • Reduces water consumption, above all during the rinse. • Especially suitable for lightly soiled or small loads (reduce the detergent quantity). Cold wash button • The water is used at the water supply temperature. Intensive rinse button • This function is especially suitable in areas with extremely soft water, for baby clothes and to help people with allergies. • This special function is recommended for the 95°C “Cotton” and 60°C “Synthetic” programmes, since in this way the wash water is cooled before drainage. 95°C Cotton • This function can be selected in the “Cotton” programme. • Suitable for fabrics with this symbol on the label. • Recommended only for heavily soiled laundry. PROGRAMME START 1. [. . . ] Do not exceed the recommended dosages on the detergent packet. Only use bleach or stain remover if absolutely necessary. • - - • - - SAFETY INSTRUCTIONS • The appliance must only be used in the household for the prescribed uses. All connections to the water and electrical mains must be made in accordance with the manufacturer's instructions and following local utility company safety regulations (see “Installation Instructions”). Before any cleaning and maintenance switch off the machine or disconnect it from the mains. [. . . ]