User manual WHIRLPOOL AWM 268 INSTRUCTION FOR USE

[. . . ] INSTALLATION INSTRUCTIONS MOBILITY WHEELS (for UK only) Depending on model, your washing machine is provided with mobility wheels. You will find these wheels in the accessory kit supplied with the machine, or you can order them from our After-Sales Service. 1 MOUNTING INSTRUCTIONS 1. Insert the wheels as close as possible to the screw (1). Adjust the front feet making sure that the machine is completely level with the floor. [. . . ] IMPORTANT: During the first 15 minutes of the Cotton and Synthetic programmes (without Prewash) you can open the door to add items to the wash. This is not possible when the special option “Quick Wash” / “Rapid” is selected. If the programme selector is set to “0” or the electrical supply is interrupted, the door lock will open after approximately 2 minutes. PROGRAMME END 1. The programme sequence indicator is at “Stop”. Only attempt to open the door after this. Set the programme selector to “0”. Cancel the special options by pressing the appropriate buttons. Note: Do not fully close the door but leave it ajar to allow the drum to dry out. PROGRAMME RESELECTION / INTERRUPTING THE PROGRAMME PROGRAMME RESELECTION a. CONTINUING WITH A NEW PROGRAMME OR TEMPERATURE SETTING 1. Select the new programme or temperature. Hold down the Start button for about 1 second. The new programme will continue fwith the same programme step at which the previous programme was interrupted. CANCELLING THE CURRENT PROGRAMME AND RESTARTING WITH A DIFFERENT ONE There's no need to add more detergent when you start the new programme, since almost no water is drained out when a programme is cancelled. Hold down the Start button for about 5 seconds or until the programme control audibly restarts. Wait until the programme sequence indicator reaches “Stop”. Set the programme selector to “0”. Set the programme selector to the new programme, selecting the new temperature and any special functions required. Hold down the Start button for about 1 second. 84 TO INTERRUPT / PAUSE A PROGRAMME To interrupt a programme that is already running and then restart it later: 1. Set the programme selector to “0”. After the desired break, reselect the programme. Hold down the Start button for about 1 second. [. . . ] Before any cleaning and maintenance switch off the machine or disconnect it from the mains. Switch off the washing machine and turn off the tap(s) whenever the machine is not in use. • • • Never use excessive force to open the door. Children must not be allowed to play with or inside the machine. [. . . ]