User manual WHIRLPOOL AWM 5140/5 INSTALLATION

[. . . ] € • • Read this “INSTALLATION GUIDE” before operating. Keep this “INSTALLATION GUIDE” for future reference. Read the general recommendations about disposing of packaging in the Instructions for use. [. . . ] Slacken the locknut clockwise (see arrow) using the wrench C supplied. Lift slightly the machine and adjust the height of the foot revolving it. Important: tighten the locknut by turning it anti-clockwise towards the appliance casing. If the water inlet hose is not already installed, it must be screwd to the appliance. Screw by hand the inlet hose onto the tap tightening the nut. attention: • no kinks in the hose!€ The appliance must not be connected to the mixing tap of an un-pressurized water heater. € Check water-tightness of connections by turning the tap completely on. € If the hose is too short, replace it with a suitable length of pressure resistant hose (1000 kPa min, EN 50084 approved type). € Check the inlet hose regularly for brittleness and cracks and replace if necessary. € The washing machine can be connected without a non-return valve. For models with Water Stop hose: If the flexible hose is too short, replace it with a 3 m Water Stop hose (available from AfterSales Service or from your dealer). This replacement is only to be carried out by a trained electrician. Depending on the model, the inlet hose and the plastic enclosure at the tap connection contain electrical components. Do not cut the hose and do not immerse the plastic enclosure in water. Isolate the appliance from the mains immediately if the hose is damaged. [. . . ] do not use extension leads or multi sockets. The electrical power cable must be replaced exclusively by a licensed electrician. Electrical connections must be made in accordance with local regulations. [. . . ]