User manual WHIRLPOOL AWM 6110/3 PROGRAM CHART

[. . . ] The Power On led lights up to indicate that the machine is switched on. Hold down the "Start" button for about 1 second. This initial cycle serves to eliminate any water remaining after your appliance was tested at the factory. Sort the wash according to fabric type and colour and load the appliance. [. . . ] • 29 REMAINING TIME / PROGRAMME SEQUENCE INDICATOR REMAINING TIME INDICATOR (if available) • • • Two digit remaining time display. If "Start delay" is used, the remaining time is displayed only after the programme has actually started. If a programme lasts longer than 99 minutes, the figure 99 will be displayed until the remaining time drops below 99 minutes. The washing machine is fitted with FuzzyLogic-Technology. The appliance adapts optimally to the current conditions in such a way as to optimise consumption even with light loads. Hold down the "Start" button for 5 seconds, or until the programme control audibly restarts and the remaining time indicator displays "00". Wait until the programme sequence indicator has returned to its initial (leftmost) position. Set the programme selector to "0". Select the new programme and any special options desired. The indicator above the "Start"-button flashes. Hold down the "Start"-button for about 1 second. TO INTERRUPT/PAUSE A PROGRAMME To interrupt a programme for a certain time and resume it later: 1. Unscrew the plastic screw using the thin rounded projection on the coloured insert from the detergent drawer. Grip the end of the drain tube and pull out about a 12 inch length. Remove the cap from the end of the tube. Allow all the water to flow into a flat bowl, then refit the plug and stow the drain tube back in its compartment. Before using the machine again, pour about 1 litre of water into the detergent dispenser to reactivate the "Eco System". 31 CARE AND MAINTENANCE APPLIANCE EXTERIOR AND CONTROL PANEL • • Clean using normal household cleaner (do not use abrasive products). Dry with a soft cloth. 2 1 2 DETERGENT DISPENSER 1. Disengage the detergent dispenser by pressing the release lever in the prewash compartment, and extract it. Remove the inserts (the siphon from the softener compartment and the insert for liquid detergents). Replace the parts and refit the detergent dispenser. Push the siphon firmly into place. DOOR SEAL • • Clean with a damp cloth when necessary. Periodically check the fold of the seal for foreign objects. WATER HOSE MESH FILTERS • Check and clean periodically. [. . . ] Connect the drain hose to the siphon or hook it over the edge of a sink by means of the "U" bend (see figure). The drain hose should not be hooked onto small washbasins. drain height: 1, 25 m (4 ft) If you need to add an extension, use a flexible hose of the same type and secure the union with screw-on hose clips. Important: Make sure there are no kinks in the hose. [. . . ]