User manual WHIRLPOOL AWM 8000/PRO PRODUCT FICHE

[. . . ] • Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous. • If the appliance was exposed to the cold prior to delivery, keep it at room temperature for a few hours before operating. • Use only new hoses to connect the washing machine to the water supply. Used hoses must not be used and should be discarded. 5. Drain • Connect the drain hose to the siphon or hook it over the edge of a sink by means of the “U” bend supplied. [. . . ] Remarks: • Any whitish residues on dark fabrics are caused by insoluble compounds used in modern phosphate-free powder detergents. If this occurs, shake or brush out the fabric or use liquid detergents. • Use only detergents and additives specifically produced for domestic washing machines. • When using descaling agents, dyes or bleaches for the pre-wash, make sure that they are suitable for use in domestic washing machines. Descalers could contain products which could damage your washing machine. Do not machine wash fabrics that have been treated with solvents or flammable liquids. • Do not use liquid detergent for the main wash when having activated the “prewash” option (if available on your model). • Do not use liquid detergent when activating the “Start Delay” function (if available on your washing machine). Dosage Follow the dosage recommendations on the detergent pack. They depend on: • degree and type of soiling • size of wash full load: follow the detergent manufacturer’s instructions; half load: 3/4 the amount used for a full load; Minimum load (about 1 kg): 1/2 the amount used for a full load • water hardness in your area (ask for information from your water company). Soft water requires less detergent than hard water (refer to the water hardness table in the operating instructions). Notes: Too much detergent can result in excess foam formation, which reduces washing efficiency. If your supply hose has a transparent hose coating (fig. “C”), periodically check the colour of the transparent coating. If the coating begins to turn red, this is an indication that the hose may have a leak and should be replaced. Contact our After-Sales Service team or specialist dealer to obtain a replacement hose. A Cleaning the mesh filter in the water supply hose(s) 1. Close the tap and loosen the inlet hose on the tap. Clean the internal mesh filter and screw the water inlet hose back onto the tap. Now unscrew the inlet hose on the rear of the washing machine. Pull off the mesh filter from the washing machine connection with universal pliers and clean it. Refit the mesh filter and screw the inlet hose on again. Turn on the tap and ensure that the connections are completely water-tight. B Safety valve inspection window C GB 9 Black process 45. 0° 100. 0 LPI 30105990GB. fm Page 10 Tuesday, February 13, 2007 11:13 AM TROUBLESHOOTING GUIDE Your washing machine is equipped with various automatic safety functions. These enable faults to be detected in good time and the safety system can react appropriately. [. . . ] • Afterwards select and start the desired programme again, using less detergent. If any of the faults described above persist, unplug the appliance, turn off the water tap and contact our After-Sales Service (see next chapter). “F09” “FA” “Service” “Fod” GB 12 Black process 45. 0° 100. 0 LPI 30105990GB. fm Page 13 Tuesday, February 13, 2007 11:13 AM AFTER-SALES SERVICE Before contacting After-Sales Service: 1. Try to remedy the problem yourself (see “Troubleshooting Guide”). Restart the programme to check whether the problem has solved itself. [. . . ]