User manual WHIRLPOOL AWM 8113/1 PROGRAM CHART

[. . . ] Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. If you select “Rinse Hold” do not leave items to soak for too long. Textiles made of silk, linen, wool and viscose marked as “handwashable”. If you select “Rinse Hold” do not leave items to soak for too long. [. . . ] • Select programme, temperature and options. • Press the “Start Delay” button to select the delay time by 1 to 23 hours; • Press the “Start/Pause” button. • The time delay indication disappears when the programme starts and it is replaced by the remaining time. • The number of hours preselected can later be reduced pressing again the “Start Delay” button. To cancel the “Start Delay”. • Turn the programme selector to the “ ” position. • Reselect the desired programme and options and press the “Start/Pause” button. PROGRAMME START Open the tap and press the “Start/Pause” button. The pilot lamp of the “Start/Pause” button lights up. The indicator lamps show the sequence reached in the programme. After starting the programme, the sequence indication runs from left to right through Wash, Rinse, Spin. When the sequence of the programme is finished the corresponding lamp goes out. DOOR LOCK The door can be opened when the “Door Open” indication is on. PROGRAMME END • The remaining time is on “0:00” and all the lights of the programme sequence indication are off. Turn the programme selector to the “ ” position. Close the tap and leave the door ajar to allow the drum to dry out. CHANGE THE PROGRAMME, TEMPERATURE, OPTIONS AFTER PROGRAMME START 1. Press the “Start/Pause” button to pause the programme. Select the new programme (with temperature), any options and another spin speed if you want. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. Press the “Start/Pause” button to pause the programme. [. . . ] • This option is particularly recommended for the programme “Synthetics”, “Daily” and “Delicates”. • This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. Whirlpool is a registered trademark of Whirlpool USA 5019 301 05354 Black process 45. 0° 100. 0 LPI 3gb05354. fm Page 3 Friday, April 26, 2002 3:58 PM HOT / COLD FILL INSTRUCTION If you wish to connect hot and cold water supply (Fig. 1): 1. Fix the red marked inlet hose at the hot water tap and at the inlet valve with the red filter on the rear side of machine. Fix the other inlet hose at the cold water tap and at the inlet valve with the blue filter on the rear side of the machine. [. . . ]