User manual WHIRLPOOL AWM 8142 PROGRAM CHART

[. . . ] If you select “Rinse Hold” do not leave items to soak for too long. Textiles made of linen, silk, wool and viscose marked as “handwashable”. If you select “Rinse Hold” do not leave items to soak for too long. A very gentle spin is used in this programme. [. . . ] **To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergent as described in the chapter “Detergents and Additives” in the booklet. Turn the programme selector knob to the desired programme. The remaining time display shows the duration of the chosen programme (in hours and minutes) and the pilot lamp of the “Start/Pause” button is flashing. The programme sequence and the predefined spin speed indication corresponding to the selected programme lights up. The recommended temperature (see the indicator) can be altered by pressing “+” or “-” button. SELECT ANY DESIDERED OPTION Selecting any option the pilot lamp lights up. An audible tone sounds if the combination of programme, additional options and temperature is not possible. Unsuitable combinations of options are deselected automatically. “Eco Wash” button • The duration of the wash is extended and the temperature reduced to save up to 40% of energy maintaining good washing results. “Easy Ironing” button • Can be used together with Cotton and Synthetics programmes to make ironing easier. • Increases the water quantity and the clothes are spun very soft. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. “Intensive Rinse” button • The water level and the rinsing time are increased. • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. “Rinse Hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the programme “Synthetics” or “Delicates”. • This function is particularly useful if you want to postpone spinning to a later time. Note: The programme stops to “Rinse Hold” at the time the “Rinse Hold” light in the programme flow indication is on. Terminate the “Rinse Hold” option: • Press the “Rinse Hold” button again; the programme will terminate automatically with the final spin cycle for the present wash programme. • If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start/Pause” button again. “Spin Speed Reduction” button • Every programme has an automatic predefined maximum spin speed. • Press the button to set another spin speed. [. . . ] Press the “Start/Pause” button to pause the programme. Select the new programme (with temperature), any options and another spin speed if you want it. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. [. . . ]