User manual WHIRLPOOL AWO 3561 PROGRAM CHART

[. . . ] Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, T revira), polyamide (Perlon, Nylon) or blends with cotton. Slightly to normally soiled textiles made of cotton and/or synthetics. Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. [. . . ] The indication next to the “Start Delay” button lights up and goes off when the programme starts. • The time delay indication disappears when the programme starts and it is replaced by the remaining time. • The number of hours preselected can later be reduced pressing again the “Start Delay” button. To cancel the “Start Delay” . . before you press the “Start/Pause” button: • Turn the programme selector to the “Off/0” position. • Reselect the desired programme and options and press “Start/Pause” button to start the programme. . . after having pressed the “Start/Pause” button: • Press the “Reset” button for at least 3 seconds the start delay time disappears from the remaining time display, then • either start the chosen programme by pressing the “Start/Pause” button twice • or turn the programme selector knob to the “Off/0” position and choose another programme. PROGRAMME START Open the tap and press the “Start/Pause” button. The indication next to the “Start/Pause” button lights up. The indications show the sequence reached in the programme. After starting the programme, the sequence indication runs from left to right through Wash, Rinse, Spin. When the sequence of the programme is finished the corresponding indication goes out. RED INDICATIONS “Water Tap Closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean Pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). “Door Locked” As long as a washing programme is running, the lamp lights up to show that the door cannot be opened. When the indication goes off, the door can be opened again. PROGRAMME END • The remaining time is on “0:00” and all the lights of the programme sequence indication are off. Turn the programme selector to the “Off/0” position. Leave the door ajar to allow the drum to dry out. CHANGE THE PROGRAMME, OPTIONS AFTER PROGRAMME START 1. Press the “Start/Pause” button to pause the programme. Select the new programme (with temperature), any options and another spin speed if you want. [. . . ] • Increases the water quantity and the clothes are spun very soft. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle time increases approximately 15 min. “Intensive Rinse” button • More water and a longer time in rinse cycle is added. • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. [. . . ]