User manual WHIRLPOOL AWO 3671 PRODUCT FICHE

[. . . ] Curtains and delicate clothing, dresses skirts, shirts and blouses. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. This programme (40°C) is tested and approved by The Woolmark Company for machine washable wool. If you select “Rinse Hold” do not leave items to soak for too long. [. . . ] For improved garment care spin speed is restricted to 400 rpm in this programme. M0501 - tested and approved by The Woolmark Company - Whirlpool is a registered trademark of Whirlpool USA 5019 301 05827 Black process 45. 0° 100. 0 LPI 30105827GB. fm Page 2 Tuesday, December 27, 2005 4:32 PM CONSUMPTION DATA Programme Cotton (Anti-bacterial) Cotton Cotton with Eco+ *** Cotton Synthetics Synthetics Daily load Quick wash Delicate Wool Handwash (Lingerie) Temperature Selector (°C) 95 60 60 40 60 40 40 30 30 30 30 Load (kg) 6. 0 6. 0 6. 0 5. 0 2. 5 2. 5 3. 0 3. 0 1. 5 1. 0 1. 0 Water (l) 54** 49 49 44 55 55 45 37 60 60 45 Energy (kWh) 1. 90 1. 14 1. 02 0. 60 0. 80 0. 60 0. 50 0. 40 0. 50 0. 30 0. 30 Approx. Programme Duration (hours : minutes)* 2:00 2:20 2:30 2:05 1:30 1:20 1:00 0:30 0:45 0:40 0:40 • This option is particularly recommended for the programme “Synthetics”, “Daily” and “Delicates”. • This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. Note: The programme stops to “Rinse Hold” at the time the “Rinse Hold” symbol is indicated on the display. The “Start/Pause” button flashes. Terminate the “Rinse Hold” option: • Press the “Start/Pause” button; the programme will terminate automatically with the final spin cycle for the present wash programme. • If you do not wish to spin the clothes, press the “Reset” button and afterwards the “Start/ Pause” button to start the “Drain” programme. FAVOURITES You have the possibility to store, for each main programme, your preferred combination of programme, options, temperature and spin speed. After having selected the desired combination, press the “Favourites” button for at least 3 sec. Next time you choose the corresponding programme, the display will show you the stored parameters, and you just have to press “Start/ Pause”. If you want to change the stored combination, just make your new choice and again press the “Favourites” button for at least 3 sec. CHANGE THE PROGRAMME, TEMPERATURE, OPTIONS AFTER PROGRAMME START 1. Press the “Start/Pause” button to pause the programme. Select the new programme (with temperature), any options and another spin speed if you want. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END • Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened. Whirlpool is a registered trademark of Whirlpool USA Prewash cycle might increase programme duration. Consumption values were measured in normalized conditions in compliance with Standard IEC / EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. [. . . ] If spin speed “0” is selected, the final spinning is cancelled, but intermediate spin peaks remain during rinse; the water is drained out only. USING CHLORINE BLEACH • Wash your laundry in the desired programme (Cotton, Synthetics), adding an appropriate amount of chlorine bleach to the SOFTENER chamber (close the detergent dispenser carefully). • Immediately after end of programme, start the “Rinse and Spin” programme to eliminate any residual bleach smell; if you want, you can add softener. SELECT SPECIAL OPTIONS Selecting any special option the indication lights up. When the combination of programme, additional options and temperature is not possible, the indication lights switch off automatically. [. . . ]