User manual WHIRLPOOL AWO 5105 INSTRUCTION FOR USE

[. . . ] Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. Curtains and delicate clothing, dresses skirts, shirts and blouses. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. This programme (40°C) is tested and approved by The Woolmark Company for machine washable wool. [. . . ] After having selected the desired combination, press the “Favourites” button for at least 3 sec. Next time you choose the corresponding programme, the display will show you the stored parameters, and you just have to press “Start/ Pause”. If you want to change the stored combination, just make your new choice and again press the “Favourites” button for at least 3 sec. The previous combination is cancelled automatically, and the new one is stored. START DELAY The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Select programme, temperature, spin speed and options. • Press the “Start Delay” button to select the delay time by 1 to 23 hours. The selected start delay is indicated on the display under “Remaining Time”. • Press the “Start/Pause” button - the countdown of the selected start delay begins. • The start delay indication disappears when the programme starts and is replaced by the remaining time. • The number of hours can be modified later by pressing the “Start Delay” button again. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END • Press the “Reset/Drain” button for at least 3 seconds. Any existing water is drained out before the door can be opened. Whirlpool is a registered trademark of Whirlpool USA Prewash cycle might increase programme duration. Consumption values were measured in normalized conditions in compliance with Standard IEC / EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. When the remaining programme duration is newly calculated, the 6th sense symbol appears on the display. ** T reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. o *** Reference programme for the energy label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergents as described in the programme table or in the chapter “Detergents and Additives” in your Instructions for Use booklet. Switch on the machine by pressing the “On/Off”-button. The blue indication lights of the main programmes and of the “Reset/Drain” button light up. Select the desired programme by pressing the corresponding button. [. . . ] • This option is particularly recommended for the programme “Synthetics”, “Daily” and “Delicates”. • This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. Note: The programme stops to “Rinse Hold” at the time the “Rinse Hold” symbol is indicated on the display. The “Start/Pause” button flashes. 5019 301 05779 Black process 45. 0° 100. 0 LPI 30105779GB. fm Page 3 Monday, July 18, 2005 6:16 PM HOT / COLD FILL INSTRUCTION If you wish to connect hot and cold water supply (Fig. 1): 1. [. . . ]