User manual WHIRLPOOL AWO 6300 PROGRAM CHART

[. . . ] Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Slightly to normally soiled textiles made of cotton and/or synthetics. Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. [. . . ] • If the spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. PROGRAMME START Open the tap and press the “Start/Pause” button. The indication next to the “Start/Pause” button lights up. The indications show the sequence reached in the programme. After starting the programme, the sequence indication runs from left to right through Wash, Rinse, Spin. When the sequence of the programme is finished the corresponding indication goes out. RED INDICATIONS “Water Tap Closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean Pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). “Door Locked” As long as a washing programme is running, the lamp lights up to show that the door cannot be opened. When the indication goes off, the door can be opened again. PROGRAMME END • The remaining time is on “0:00” and all the lights of the programme sequence indication are off. Turn the programme selector to the “Off/0” position. Leave the door ajar to allow the drum to dry out. CHANGE THE PROGRAMME, TEMPERATURE, OPTIONS AFTER PROGRAMME START 1. Press the “Start/Pause” button to pause the programme. Select the new programme (with temperature), any options and another spin speed if you want. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. • Press the “Reset” button for at least 3 seconds. [. . . ] “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle time increases approximately 15 min. “Intensive Rinse” button • More water and a longer time in rinse cycle is added. • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. “Rinse Hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. [. . . ]