User manual WHIRLPOOL AWO 6646 INSTRUCTION FOR USE

[. . . ] Make sure to wash only similar colours together in one wash load. Yes Shortly worn clothing made of cotton, polyester, polyamide and blends with cotton. Brief programme to refresh your laundry. Textiles made of wool, linen, viscose or silk (respect care label!) marked as hand-washable or machine-washable. This programme, at 40° C, is tested and approved by the Woolmark Company for machine- and handwashable wool textiles which are labelled with the Woolmark. [. . . ] Spin speed on display blinks: unbalance during spinning. Consumption values were measured in normalized conditions, in compliance with IEC/EN 60456. In the home, they may vary depending on the individual water supply pressure and temperature, the load and the type of wash. The consumption data indicated are based on an inlet water temperature of approx. 15°C through the cold fill valve as well as the hot fill valve (if available). If your washing machine has a hot fill valve, connection of this valve to hot water supply will lower the energy consumption by reduced heating times, depending on the individual hot fill inlet water temperature. Water and energy consumptions refer to the default setting of the programmes, with temperature and load as indicated in the table; selecting any options or changing the spin speed will also change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). * ** *** Reference programmes for Energy Label. To reduce the water temperature, some cold water is added at the end of the main wash cycle before the water is drained. Automatic adaptation of programme duration after detection of wash load. terminate automatically with the final spin cycle for the If you do not wish to spin the clothes, turn the programme selector to the “Drain” programme and press the “Start/ Pause” button “Spin” button • • Every programme has a predefined spin speed; press the button if you want to set a different spin speed. If spin speed “0” is selected, the final spinning is cancelled and the water is drained out only. However, intermediate spin phases remain during rinse. to start draining. LOAD LAUNDRY, ADD DETERGENT AND SELECT THE PROGRAMME Load the laundry, close the door and add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme and temperature. The display shows the programme duration and the predefined spin speed. The “Start/Pause” indicator blinks. “Clean +” button • Choose this option if you use an in-wash additive for stain removal (powder, for example “Vanish”) - it will optimize the additive’s efficiency to get better wash performance and stain removal. Add an appropriate amount of in-wash additive for stain removal (powder) to the main wash chamber, together with your detergent (only use powder detergent with this option). Respect the manufacturer’s dosing instructions. • May prolong the programme by up to 15 minutes. Appropriate for use of stain removers and bleaches on oxygen basis. Chlorine or perborate bleaches must not be used!“Cold wash” button • • • • Saves energy used for water heating while maintaining a good wash result. [. . . ] The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. On the display, the start delay symbol and the dot between hours and minutes blink. The delay time indicator disappears when the programme starts and it is replaced by the remaining programme duration. Once having pressed the “Start/Pause” button , the delay time can be changed by pressing again the “Start delay” button. [. . . ]