User manual WHIRLPOOL AWO 8066/1 PROGRAM CHART

[. . . ] The bacteria removal efficiency has been tested following a similar methodology to the NF EN 13697 standard of Nov. With heavily soiled laundry the additional “Prewash” option can be selected as well. Normally to heavily soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. [. . . ] • If you do not wish to spin the clothes, turn the programme selector knob counterclockwise to the “Drain” programme and press the “Start/Pause” button again when the indication next to it is flashing. “Spin Speed” button • Every programme has an automatic predefined maximum spin speed. • Press the button to set another spin speed. • If the spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. START DELAY The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Select programme, temperature and options. • Press the “Start Delay” button to select the delay time by 1 to 23 hours; • Press the “Start/Pause” button. The indication next to the “Start Delay” button lights up and goes off when the programme starts. • The time delay indication disappears when the programme starts and it is replaced by the remaining time. • The number of hours preselected can later be reduced pressing again the “Start Delay” button. To cancel the “Start Delay” . . before you press the “Start/Pause” button: • T the programme selector to the “Off/0” position. urn • Reselect the desired programme and options and press “Start/Pause” button to start the programme. . . after having pressed the “Start/Pause” button: • Press the “Reset” button for at least 3 seconds the start delay time disappears from the remaining time indication, • then either start the chosen programme by pressing the “Start/Pause” button twice • or turn the programme selector knob to the “Off/0” position and chose another programme. PROGRAMME START Open the tap and press the “Start/Pause” button. The indication next to the “Start/Pause” button lights up. The indications show the sequence reached in the programme. After starting the programme, the sequence indication runs from left to right through Wash, Rinse, Spin. When the sequence of the programme is finished the corresponding indication goes out. RED INDICATIONS “Water Tap Closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean Pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). [. . . ] • Increases the water quantity and the clothes are spun very soft. “Eco plus” button • With a modified temperature profile and a slightly prolonged washing duration, the optimum combination of excellent washing result and even lower energy consumption can be achieved. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. The cycle time increases approximately 15 min. [. . . ]