User manual WHIRLPOOL AWO 9125 PROGRAM CHART

[. . . ] blouses, shirts, 2. 5 Normally to heavily soiledwith cotton. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends ❉ Yes ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ 1200 Synthetics Pflegeleicht 30 - 40 - 60 °C ❉ — — ❉ — — — — — — Yes Yes Yes Yes Yes ❉ ❉ ❉ ❉ ❉ ❉ ❉ — — — ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — ❉ ❉ ❉ — — — ❉ — — — ❉ — — — — — — — — — ❉ — — ❉ — — — — — — ❉ ❉ ❉ — — — ❉ — — — ❉ ❉ ❉ ❉ ❉ ❉ ❉ — — — ❉ 1) ❉ ❉ ❉ 1) ❉ 1) ❉ 2) ❉ ❉ ❉ 1) — 1000 1) 1200 1200 1000 1) 1000 1) 400 2) 1200 1200 1000 1) Daily load Mischwäsche 40 °C 3. 0 Slightly to normally soiled textiles made of cotton and/or synthetics. 3. 0 Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. 1. 5 Curtains and delicate clothing, dresses skirts, shirts and blouses. [. . . ] The selected start delay is indicated on the display under “Remaining Time”. • Press the “Start/Pause” button - the countdown of the selected start delay begins. • The start delay indication disappears when the programme starts and is replaced by the remaining time. • The number of hours can be modified later by pressing the “Start Delay” button again. To cancel the “Start Delay” • Press the "Reset" button for at least 3 seconds the start delay time disappears from the remaining time indication. PROGRAMME START Open the tap and press the “Start/Pause” button. The blue lamp under the “Start/Pause” button stops flashing and lights up. The display indicates the sequence reached in the programme by the corresponding symbol. When the programme sequence is finished, the corresponding symbol disappears. Under “Remaining Time”, the display indicates the remaining programme duration. BLUE “DOOR LOCKED” INDICATION As long as a washing programme is running, the lamp lights up to show that the door cannot be opened. When the indication goes off, the door can be opened again. RED INDICATIONS “Clean filter” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). “Water tap closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Water stop” Lighting up of the water stop indication can be caused by a leak in the appliance or hose. Please refer to the “Troubleshooting Guide” in the Instructions for Use. PROGRAMME END • On the display, the “Remaining time” disappears and “End” is indicated. Switch the machine off by pressing the “On/Off”-button. Leave the door ajar to allow the drum to dry out. CHANGE THE PROGRAMME, TEMPERATURE, OPTIONS AFTER PROGRAMME START 1. [. . . ] “Easy Ironing” button • Can be used together with “Cotton”, “Synthetics” and “Daily” programmes to make ironing easier. • Increases the water quantity and the clothes are spun very soft. “Eco” button • With a modified temperature profile and a slightly prolonged washing duration, the optimum combination of excellent washing result and even lower energy consumption can be achieved. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. [. . . ]