User manual WHIRLPOOL AWO/C 3127 P PRODUCT FICHE

[. . . ] Textiles made of linen, silk, wool and viscose marked as “handwashable”. If you select “Rinse hold” do not leave items to soak for too long. A very gentle spin is used in this programme. This cycle is particularly suitable to treat delicate lingerie (use of a laundry net strongly recommended). [. . . ] For improved garment care spin speed is restricted to 400 rpm in this programme. Whirlpool is a registered trademark of Whirlpool USA. 5019 301 10413 CONSUMPTION DATA Programme Cotton Cotton Cotton with “Eco”*** Cotton Synthetics Synthetics Delicates Daily load Quick wash Wool Handwash Lingerie Temperature (°C) 95 60 60 40 60 40 30 40 30 40 40 30 Load (kg) 5. 0 5. 0 5. 0 5. 0 2. 5 2. 5 1. 5 3. 0 3. 0 1. 0 1. 0 1. 0 Water (l) 49** 44 44 44 50** 45 50 45 40 55 45 45 Energy (kWh) 1. 90 0. 95 0. 85 0. 60 0. 70 0. 55 0. 50 0. 45 0. 40 0. 60 0. 60 0. 50 Approx. Programme Duration (hours : minutes)* 2:00 2:10 2:20 2:00 1:30 1:15 0:45 1:00 0:30 0:45 0:40 0:40 “Variable spin” button • Every programme has a predefined spin speed. • Press the button to set another spin speed. • If spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. START DELAY The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Select programme, temperature and options. • Press the “Start delay” button to select the delay time by 1 to 23 hours. • Press the “Start/Pause” button. The indication light next to the “Start delay” button lights up and the countdown of the delay time begins. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • Once having pressed the “Start/Pause” button, the number of hours preselected can be reduced by pressing again the “Start delay” button. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. *** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergents as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme and temperature. The time display shows the duration of the chosen programme (in hours and minutes), and the “Start/Pause” indication lamp is flashing. The indication lamp of the predefined spin speed lights up. SELECT ANY DESIRED OPTION Push the button(s) of any option(s) desired - the respective indication lamp lights up. [. . . ] Increases the cycle time by approximately 15 min. “Easy ironing” button • Can be used together with “Cotton”, “Synthetics” and “Daily load” programmes to make ironing easier. • Increases the water quantity and the clothes are spun very gently. “Intensive rinse” button • More water is added and rinse cycle is prolonged. • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. [. . . ]