User manual WHIRLPOOL AWO/C 6120/1 PRODUCT FICHE

[. . . ] Textiles made of linen, silk, wool and viscose marked as “handwashable”. If you select “Rinse Hold” do not leave items to soak for too long. A very gentle spin is used in this programme. This cycle is particularly suitable to treat delicate lingerie (use of a laundry net strongly recommended). kg Cotton / Antibacterial 40 - 60 - 95 °C / 5. 0 ❉ Yes ❉ ❉ ❉ ❉ ❉ ❉ ❉ 800 Synthetics 30 - 40 - 60 °C Delicates 30 - 40 °C 2. 5 1. 5 3. 0 3. 0 1. 0 1. 0 1. 0 5. 0 5. 0 1. 0 — ❉ ❉ — — — — — — — — — Yes Yes Yes Yes Yes Yes Yes — — — — ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — — — ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — ❉ ❉ — — — — — — — — — ❉ — — — — — — — — — — ❉ — ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — — — ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — 800 800 800 800 800 400 1) 400 1) 800 800 800 — Daily load 40 °C ❉ — — — — Quick wash 30 °C Wool Cold - 40 °C Handwash 40 °C Lingerie 30 °C Rinse & Spin Spin Gentle Spin Drain — — — — Same as the last rinse and the final spin in the “Cotton” programme. [. . . ] Alternative method of terminating programme after “Rinse Hold”. ❉ — — — ❉: 1) optional / Yes : dosing required For improved garment care, spin speed is restricted to 400 rpm in this programme. Whirlpool is a registered trademark of Whirlpool USA 5019 301 10306 CONSUMPTION DATA Temperature Programme Cotton / Antibacterial Cotton Cotton with “Eco”*** Cotton Synthetics Synthetics Delicates Daily load Quick wash Wool Handwash Lingerie (°C) 95 60 60 40 60 40 30 40 30 40 40 30 (kg) 5. 0 5. 0 5. 0 5. 0 2. 5 2. 5 1. 5 3. 0 3. 0 1. 0 1. 0 1. 0 (l) 49** 44 44 44 50** 45 50 45 40 55 45 45 (kWh) 1. 90 1. 05 0. 95 0. 60 0. 70 0. 55 0. 50 0. 45 0. 40 0. 60 0. 60 0. 50 Load Water Energy Approx. Programme Duration (hours : minutes)* 2:00 2:10 2:20 2:00 1:30 1:15 0:45 1:00 0:30 0:45 0:40 0:40 “Variable spin” button • Every programme has a predefined spin speed. • Press the button to set another spin speed. • If spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. START DELAY The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Select programme, temperature and options. • Press the “Start Delay” button to select the delay time by 1, 3, 6, 9 or 12 hours. • Press the “Start/Pause” button. The indication next to the “Start Delay” button lights up and goes off when the programme starts. • Once having pressed the “Start/Pause” button, the countdown of the time delay begins. When the programme starts, the start delay indicator light goes off and is replaced by the programme sequence indication. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. • Press the “Reset” button for at least 3 seconds. Any existing water is drained out before the door can be opened. Whirlpool is a registered trademark of Whirlpool USA Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. *** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Close the door and turn the programme selector to the desired programme and temperature. The indication lamp next to the “Start/Pause” button flashes. [. . . ] When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. Increases the cycle time by approximately 15 min. [. . . ]