User manual WHIRLPOOL AWO/C M7120 PRODUCT FICHE

[. . . ] Shortly worn clothing made of cotton, polyester, polyamide and blends with cotton. Brief programme to refresh your laundry. Only woollens, labelled with the Woolmark and identified as machine washable. Textiles made of linen, silk, wool and viscose marked as “handwashable”. [. . . ] Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. Alternative method of terminating programme after “Rinse Hold”. Prewash Main Wash Softener Max Spin Speed rpm Antibacterial 95 °C Cotton/ 6. 0  Yes   –     Max. Cotton 40 - 60 °C 6. 0 3. 0 1. 5 3. 0 3. 0 1. 0 1. 0 1. 0 – – – – 6. 0 6. 0 1. 0 –    – – – – – – – – – Yes Yes Yes Yes Yes Yes Yes Yes – – – –          – – –               – – – – – – – – – –    – – – – – – – – –   –  – – – –  – – –          – – –            – Max. 1000 1) – Synthetics 30 - 40 - 60 °C Delicates 30 - 40 °C Daily load 40 °C Quick wash 30 °C Wool Cold - 40 °C 40 °C Handwash Lingerie 30 °C Rinse & Spin Spin Short spin Drain  : option / Yes : dosing required 1) For improved garment care spin speed is restricted in these programmes. Whirlpool is a registered trademark of Whirlpool USA. 5019 301 01207 CONSUMPTION DATA Programme Cotton/ Antibacterial Cotton ** Cotton ** Cotton Cotton ** Synthetics Synthetics Delicates Daily load Quick wash Wool Handwash Lingerie Temperature (°C) 95 60 60 40 40 60 40 30 40 30 40 40 30 Load (kg) 6. 0 6. 0 3. 0 6. 0 3. 0 3. 0 3. 0 1. 5 3. 0 3. 0 1. 0 1. 0 1. 0 Water (l) 59* 49 37 54 37 50* 46 50 45 40 55 45 45 Energy (kWh) without “Rapid” 1. 90 0. 90 0. 69 0. 65 0. 58 0. 70 0. 50 0. 50 0. 45 0. 40 0. 60 0. 60 0. 50 Approx. programme duration (hours : minutes) without “Rapid” with “Rapid” 2:00 4:00 2:20 2:45 2:30 1:30 1:15 0:45 1:00 0:30 0:45 0:40 0:36 2:30 *** 1:45 *** 1:09 0:54 - “Spin” button • Every programme has a predefined spin speed. • Press the button to set another spin speed. • If spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. The water is drained out only. START DELAY FAILURE INDICATIONS In case of any failures or irregularities, consult the “Troubleshooting Guide” in your Instructions for Use. “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. “Water tap closed” The washing machine has no or insufficient water supply; the water tap might be closed or the water inlet hose kinked. “Clean pump” Waste water is not pumped out. • If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start(Pause)” button. The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. Do not use liquid detergent when activating “Start delay” option. • Select programme, temperature and options. • Press the “Start delay” button to select the delay time by 1, 3, 6, 9 or 12 hours. • Press the “Start(Pause)” button. The indication next to the “Start delay” button blinks and the countdown of the delay time begins. • The time delay indication disappears when the programme starts and it is replaced by the programme sequence indication. • Once having pressed the “Start(Pause)” button, the delay time can be reduced by pressing again the “Start delay” button. To cancel the “Start delay” . . before you press the “Start(Pause)” button: • Turn the programme selector to another position or press the “Reset” button. . . after having pressed the “Start(Pause)” button: • Press the “Start(Pause)” button - the light of the selected start delay goes off. Press “Start(Pause)” again if you want to start the selected programme immediately. PROGRAMME START • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. [. . . ] Leave the door ajar to allow the drum to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Drain/Spin. When the programme phrase is finised, the corresponding indication goes out. “DOOR OPEN” INDICATION 1. [. . . ]