User manual WHIRLPOOL AWO/D 42682 PRODUCT FICHE

[. . . ] Normally to heavily soiled and robust white cotton laundry. White and pastel shaded garments made of delicate fabrics. 7. 0 Save energy by selecting a lower wash temperature and adding an oxygen-based bleach product, in 5. 0 Gentle wash programme to avoid graying or yellowing of your laundry. Use heavy duty detergent, if necessary also stain removers or bleaches on oxygen basis. Do not use liquid detergent. Yes Yes Yes 5. 0 Special programme to reduce colour fading and local discolouration. [. . . ] ❉ ❉ max. ❉: 1) optional / Yes : dosing required For improved garment care, spin speed is restricted in these programmes. The wool/handwash cycle of this machine has been tested and approved by The Woolmark Company for the washing of Woolmark garments labelled as “machine wash” or “hand wash” provided that the garments are washed according to the instructions on the garment label and those issued in this programme chart. M0702 Whirlpool is a registered trademark of Whirlpool USA 5019 301 06561 CONSUMPTION DATA Temperature Programme (°C) Mixed Cotton Cotton* Cotton* Cotton Cotton* Synthetics Synthetics Delicates Wool/Handwash White Light colours Dark SuperEco AquaEco Speed 15 Sport 40 95 60 60 40 40 60 40 30 40 40 40 40 60 40 30 30 (kg) 4. 0 7. 0 7. 0 3. 5 7. 0 3. 5 3. 0 3. 0 1. 5 1. 0 7. 0 5. 0 5. 0 7. 0 3. 0 3. 0 3. 0 (l) 48 74** 54 42 69 42 46** 42 60 45 69 65 45 69 19 30 52 (kWh) 0. 50 2. 10 0. 91 0. 85 0. 80 0. 60 0. 80 0. 40 0. 50 0. 55 0. 80 0. 50 0. 60 0. 84 0. 45 0. 20 0. 50 Load Water Energy Approx. Programme Duration (hours : minutes) without “Rapid” with “Rapid” 1:00 — 2:10 — 4:00 2:30 3:00 *** 2:45 1:45 3:30 *** 1:35 1:14 1:20 0:59 0:45 — 0:40 *** 2:45 — 1:20 — 1:40 1:15 4:00 — 1:00 — 0:15 — 1:34 1:13 SET A START DELAY The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Select programme, temperature, spin speed and options. • Press the Start delay button to select a delay time up to 23 hours. • Press the “Start/Pause” button . The countdown of the delay time begins; the start delay symbol and the colon between hours and minutes blink. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • If you use the “Dosing Aid” button: select the delay time BEFORE pressing the “Dosing Aid” button. The countdown of the selected delay time begins after having pressed the “Start/Pause” button for the second time (see separate Instructions for Use concerning the “Dosing Aid”). To cancel the “Start delay” . . . before you press the “Start/Pause” button: • Press the “Reset/Drain” button , or set the start delay time to “0:00” - the delay time disappears after a few seconds. If the symbol lights up and the display shows “Fod”, too much foam interrupted the wash process; refer to the “Troubleshooting Guide” in your Instructions for Use. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme; the light of the “Start/Pause” button blinks. The temperature and spin speed indicated on the display can be altered by pressing the “Temperature” button or the “Spin” button . SELECT ANY DESIRED OPTION When the combination of programme and additional option(s) is not possible, the indication switch off automatically. Unsuitable combinations of options are deselected automatically. For certain programmes, an option may already be preset; if you want you can deselect it. “Clean +” button • Choose this option if you use an in-wash additive for stain removal (powder, for example “Vanish”) - it will optimize the additive’s efficiency to get better wash performance and stain removal. • Add an appropriate amount of in-wash additive for stain removal (powder) to the main wash chamber, together with your detergent (only use powder detergent with this option). Respect the manufacturer’s dosing instructions. • May prolong the programme by up to 15 minutes. • Appropriate for use of stain removers and bleaches on oxygen basis. Chlorine or perborate bleaches must not be used! [. . . ] However, intermediate spin phases remain during the rinse. • If you select “Rinse hold” , the laundry remains in the last rinse water without progressing to the final spin cycle, to avoid creasing and prevent colours from changing. To activate the “Rinse hold”, press the “Spin” button repeatedly until the “Rinse hold” symbol on the display lights up. - The wash programme stops to “Rinse hold” when the “Rinse hold” light in the programme sequence indicator is on; the light of “Start/Pause” button blinks. [. . . ]