User manual WHIRLPOOL AWO/D 43136 PRODUCT FICHE

[. . . ] If in doubt, do not use the washing machine. Contact After-Sales Service or your local retailer. • Check that the accessories and supplied parts are all present. • Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous. [. . . ] Place a container near the washing machine. If your washing machine has an emergency drain hose: - Unclip the emergency drain hose, or pull out the emergency drain hose from the washing machine’s base (depending on the model). - If there is no emergency drain hose: place a broad, flat container beneath the filter (picture “D”). Ignore steps 5 - 8 and proceed with 9. Hold the emergency hose’s end into the container and remove the stopper (picture “C”). Wait until all the water has drained, then refix the stopper at the hose’s end (picture “E”). Refix the emergency drain hose to the clip, or push it back into the washing machine’s base (depending on the model). a towel) on the floor in front of the filter. Slowly open the filter by turning it counter-clockwise (picture “F”); wait until all the water has drained, then unscrew the filter completely and remove it. Tilt the appliance forwards carefully (a second person must help you) to allow the water to flow out completely. Clean the filter and the filter chamber; check that the pump rotor in the filter chamber moves freely. Clean the internal mesh filter and screw the water inlet hose back onto the tap. Now unscrew the inlet hose on the rear of the washing machine. Pull off the mesh filter from the washing machine connection with universal pliers and clean it. Refit the mesh filter and screw the inlet hose on again. Turn on the tap and ensure that the connections are completely water-tight. D E GB 7 TROUBLESHOOTING GUIDE Your washing machine is equipped with various automatic safety functions. These enable faults to be detected in good time and the safety system can react appropriately. These faults are frequently so minor that they can be removed within a few minutes. Problem Appliance does not start, no indicator lamps are on Causes - Solutions - Tips • Plug is not properly inserted in socket. • Socket or fuse does not function correctly (use a table lamp or similar appliance to test it). • The “On/Off” button has not been pressed (if available on your model). Appliance does not start • Door is not properly closed. although “Start(Pause)” • The “Child lock/Lock buttons” feature has been activated (if available on has been pressed your model). [. . . ] If the floor is uneven, adjust the 4 levelling feet as required; do not insert pieces of wood etc. Screw out the washing machine´s feet by hand with 2-3 clockwise turns and then slacken the locknut by wrench (see pict. Slightly lift the machine and adjust the height of the foot revolving it (pict. Important: tighten the locknut by turning it anticlockwise towards the appliance casing (pict. [. . . ]