User manual WHIRLPOOL AWO/D 53110 INSTRUCTION FOR USE

[. . . ] “Reset” button Programme Cotton 95 °C 95 °C 30 - 40 - 60 °C 60 °C 40 °C Care Labels Max. Load kg 5. 0 5. 0 2. 5 2. 5 3. 0 1. 5 3. 0 1. 0 1. 0 Type of wash / Notes - Respect the manufacturer's recommendations on the care label Max. 1000 2) – Heavily soiled, long wearing and temperature stable textiles in cotton and linen (bed linen, table linen and underwear, shirts etc. ). [. . . ] In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. Same as the spin cycle in the “Wool” programme. 30 - 40 - 60 °C with prewash 60 °C Cotton Synthetics Synthetics 40 °C Daily wash 30 - 40 °C 30 °C 30 °C 30 - 40 °C 30 °C 30 °C 30 - 40 °C 30 - 40 °C – – – –       – – –         – Delicates Quick wash Wool 30 - 40 °C Handwash 30 - 40 °C Rinse & Spin Spin Gentle Spin Drain  : option / Yes : dosing required 1) 2) 5. 0 5. 0 1. 0 – Water is drained only - no spinning. Do not use liquid detergent for main wash when activating the prewash For improved garment care spin speed is restricted in these programmes. Whirlpool is a registered trademark of Whirlpool USA. 5019 301 01162 CONSUMPTION DATA PROGRAMME START PROGRAMME END Programme Cotton Cotton ** Cotton Synthetics Daily wash Delicates Quick wash Wool Handwash Handwash Temperature Selector (°C) 95 60 40 40 40 Load (kg) 5. 0 5. 0 5. 0 2. 5 3. 0 Water (l) 49 * 44 44 45 45 Energy (kWh) 1. 90 0, 95 0. 60 0. 55 0. 45 Approx. Programme Duration (hours : minutes) 2:00 2:20 2:00 1:15 1:00 Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. When the programme phrase is finised, the corresponding indication goes out. “DOOR OPEN” INDICATION • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. Turn the programme selector to the “Off/ O” position. Leave the door ajar to allow the drum to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 30 30 40 40 30 1. 5 3. 0 1. 0 1. 0 1. 0 50 40 55 45 45 0. 50 0. 40 0. 60 0. 60 0. 50 0:45 0:30 0:45 0:40 0:36 Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programme for Energy Label. Before starting and after end of a programme, the lamp lights to show the the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME SELECT ANY DESIRED OPTION Add detergents as indicated on the front page and as described in your Instructions for Use. Close the door and turn the programme selector to the desired programme and temperature. The indication lamp next to the “Start/Pause” button blinks. Push the button(s) of any option(s) desired - the respective indication lamp lights up. When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. [. . . ] Press the “StartPause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. [. . . ]