User manual WHIRLPOOL AWO/D 67010 PROGRAM CHART

[. . . ] Only woollens, labelled with the woolmark and identified as machine washable. ❉ Yes ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ max. Synthetics Sintetici 20 - 60 °C ❉ Yes ❉ ❉ ❉ ❉ ❉ ❉ ❉ — — — ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — ❉ ❉ — — — — — — — — ❉ ❉ — — — — ❉ — — — ❉ ❉ ❉ ❉ ❉ ❉ ❉ — — — ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ ❉ — max. Daily load Quick wash Delicates Wool 20 - 60 °C — — ❉ — — — — — — Yes Yes Yes Yes Yes — — — — — — — — — — — ❉ — — — — — — max. max. Rapido Delicati Lana 20 - 30 °C 20 - 40 °C 20 - 40 °C Handwash Lavaggio a mano 20 - 40 °C Rinse & Spin Spin Gentle Spin Drain Risciacquo & Centrifuga Centrifuga Centrifuga breve Scarico acqua Textiles made of silk, linen, wool and viscose marked as 1. 0 “handwashable”. — — — — — — — — 6. 0 Same as the last rinse and the final spin in the “Cotton” programme. 6. 0 1. 0 — In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. [. . . ] The display shows the remaining programme time. Due to variations in load and temperature of inlet water, the remaining time is newly calculated in certain programme phases. If this is the case, an animation appears on the display. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Cancel (Reset) a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your Instructions for Use; if the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. Turn the programme selector to the “Off/O” position. Leave the door ajar to allow the drum to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the “Start/Pause” button to pause the programme. Select the new programme, temperature, any options and another spin speed if you want. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. • Press the “Reset” button for at least 3 seconds. [. . . ] “Intensive rinse” button • More water is added and rinse cycle is prolonged. • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. “Rinse hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the programmes “Synthetics”, “Daily load” and “Delicates”. [. . . ]