User manual WHIRLPOOL AWO/D 7735 AS W INSTRUCTION FOR USE

[. . . ] Textiles made of silk, linen, wool and viscose marked as “handwashable”. This programme (40°C) is tested and approved by The Woolmark Company for handwashable wool. This programme is particurarly suitable to treat delicate lingerie (use of laundry net strongly recommended). Same as the last rinse and the final spin in the “Cotton” programme. [. . . ] ** Reference programmes for Energy Label. *** Automatic adaptation of programme duration after detection of wash load ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergents as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. • Turn the programme selector to the desired programme and temperature. • The display shows the programme duration and the predefined spin speed. • The indication lamp next to the “Start/Pause” button blinks. SELECT ANY DESIRED OPTION Push the button of any option desired - the respective indication lamp lights up. If the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt). Increases the cycle time by approximately 15 min. • Do not use liquid detergent for the main wash when activating the “Prewash” option. • Select programme, temperature and options. • Press the “Start delay” button to select the desired delay time between 30 minutes and 23 hours. • Press the “Start/Pause” button. On the display, the start delay symbol and the dot between hours and minutes blink. The countdown of the delay time begins. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • Once having pressed the “Start/Pause” button, the delay time can be reduced by pressing again the “Start delay” button. To cancel the “Start delay” • Turn the programme selector to another position, or press the “Start/Pause” button - the selected start delay disappears from the display. Press “Start/ Pause” again if you want to start the selected programme immediately. PROGRAMME START Open the tap and press the “Start/Pause” button. The indication lamp next to the “Start/Pause” button lights up. [. . . ] The drain hose may be kinked or the filter must be cleaned (see “Cleaning the filter” in your Instructions for Use). PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. 1. Turn the programme selector to the “Off/O” position. 3. Open the door and unload the machine. [. . . ]