User manual WHIRLPOOL AWO/D 7828 W PROGRAM CHART

[. . . ] 1. 0 This programme is particularly suitable to treat delicate lingerie (use of a laundry net strongly recommended). Yes Yes Lingerie 30 °C Rinse & Spin Spin Gentle Spin Drain — — — — 7. 0 Same as the last rinse and the final spin in the “Cotton” programme. 7. 0 In this programme spinning is intensive. Same as the spin cycle in the “Cotton” programme. 1. 0 In this programme spinning is gentle. [. . . ] “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme and temperature. The time display shows the duration of the chosen programme (in hours and minutes), and the “Start blinks. (Pause)” indication lamp The indication lamp of the predefined spin speed lights up. 3. SELECT ANY DESIRED OPTION Push the button(s) of any option(s) desired - the respective indication lights up. When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt) sensible. Increases the cycle time by approximately 15 min. • Do not use liquid detergent for the main wash when activating the “Prewash” option. “Eco” button • With a modified temperature profile and a prolonged programme duration, the optimum combination of good washing result and lower energy consumption is achieved. “Intensive rinse” button • More water is added and rinse cycle is prolonged. • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. “Rinse hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the programmes “Synthetics”, “Daily load” and “Delicates”. • It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. • If you select “Rinse hold” do not leave the laundry items to soak for too long. Note: The programme stops to “Rinse hold” at the time the “Rinse hold” light in the programme sequence indication is on. The indication lamp next to the “Start blinks. (Pause)” button Terminate the “Rinse hold” option : • Press the “Start (Pause)” button ; the programme will terminate automatically with the final spin cycle for the present wash programme. [. . . ] The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. The time display shows the remaining programme time. Due to variations in load and temperature of inlet water, the remaining time is newly calculated in certain programme phases. If this is the case, an animation appears on the time display. [. . . ]