User manual WHIRLPOOL AWO/D AS 148 W INSTRUCTION FOR USE

[. . . ] Brief programme to refresh your laundry. Only woollens, labelled with the Woolmark and identified as machine washable. Textiles made of silk, linen, wool and viscose marked as “handwashable”. This programme is particurarly suitable to treat delicate lingerie (use of laundry net strongly recommended). [. . . ] *** Automatic adaptation of programme duration after detection of wash load Note: The programme stops to “Rinse hold” at the time the “Rinse hold” lights in the preogramme sequence indication is on. The indication lamp next to the “Start/Pause” button blinks. Terminate the “Rinse hold” option: • Press the “Start/Pause” button; the programme will terminate automatically with the final spin cycle for the present wash programme. • If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start/Pause” button. “Spin” button • Every programme has a predefined spin speed. • Press the button to set different spin speed. • If spin speed “0” is selected, the final spinning is cancelled but intermediate spin peaks remain during rinse. “Prewash” button • Only for heavily soiled loads (for example sand, granular dirt). Increases the cycle time by approximately 15 min. • Do not use liquid detergent for the main wash when activating the “Prewash” option. “Rapid” button • Enables quicker washing by shortening the programme duration. PROGRAMME END • All the lights of the programme sequence indicator are off, and the “Door open” indication lights up. 1. Turn the programme selector to the “Off/O” position. 3. Open the door and unload the machine. 4. Leave the door ajar to allow the drum to dry. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the “Start/Pause” button to pause the programme. 2. Select the new programme (with temperature), any options and another spin speed if you want. 3. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. CANCEL (RESET) A RUNNING PROGRAMME BEFORE THE END The “Reset” button cancels a programme before the end. • Press and hold the “Reset” button for a few seconds. [. . . ] • Add an appropriate amount of in-wash additive for stain removal (powder) to the main wash chamber, together with your detergent (only use powder detergent with this option). Respect the manufacturer’s dosing instructions. • Prolongs the programme by approx. • Appropriate for use of stain removers and bleaches on oxygen basis. Chlorine or perborate bleaches must not be used! [. . . ]