User manual WHIRLPOOL AWOD 7121 INSTRUCTION FOR USE

[. . . ] Normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Curtains and delicate clothing, dresses, skirts, shirts and blouses. Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. [. . . ] Textiles made of linen, silk, wool and viscose marked as "handwashable". A very gentle spin is used in this programme. Same as the last rinse and the final spin in the "Cotton" programme. In this programme spinning is intensive. Same as the spin cycle in the "Cotton" programme. Same as the spin cycle in the "Wool" programme. Water is drained only without any spinning. Alternative method of terminating programme after "Rinse Hold". Max. Spin Speed rpm Max. Cotton with prewash 95 °C Cotton 60 - 95 °C Cotton 40 °C Synthetics with prewash 60 °C Synthetics 30 - 40 - 60 °C Delicates 30 °C Quick wash 30 °C Wool Cold - 40 °C Handwash 30 - 40 °C Rinse & Spin Spin Gentle Spin Drain : 1) 2) 6. 0 6. 0 5. 0 2. 5 2. 5 1. 5 3. 0 1. 0 1. 0 ­ ­ ­ ­ Yes Yes 1) ­ ­ Yes Max. Yes ­ ­ ­ ­ ­ ­ ­ ­ ­ Yes 1) Yes Yes Yes Yes Yes ­ ­ ­ ­ ­ 1000 2) 1000 2) 1000 2) ­ ­ ­ ­ ­ ­ ­ ­ ­ ­ Max. 1000 2) 400 2) 6. 0 6. 0 1. 0 ­ Max. Max. 1000 2) ­ option / Yes : dosing required Do not use liquid detergents. · This option is particularly recommended for the programmes "Synthetics" and "Delicates". · It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. · If you select "Rinse hold" do not leave items to soak for too long. Note: The programme stops to "Rinse hold" at the time the "Rinse hold" light in the programme sequence indication is on. The indication lamp next to the "Start/Pause" button flashes. Terminate the "Rinse hold" option: · Press the "Start/Pause" button; the programme will terminate automatically with the final spin cycle for the present wash programme. · If you do not wish to spin the clothes, turn the programme selector knob to the "Drain" programme and press the "Start/Pause" button. "Service" Lighting up of the "Service" indication can be caused by a fault in an electrical component. Refer to the "Troubleshooting Guide" in your "Instructions for Use"; if the fault persists, contact our After Sales Service. "Water tap closed" The appliance has no or insufficient water supply. Open the water tap: if the indications still lights up, refer to the "Troubleshooting Guide" in the Instructions for Use. [. . . ] Open the water tap: if the indications still lights up, refer to the "Troubleshooting Guide" in the Instructions for Use. "Clean pump" Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned: in the latter case refer to the Instructions for Use ("Removing the Filter"). 1. Press the "Start/Pause" button to pause the programme. [. . . ]