User manual WHIRLPOOL AWOD 7141 B PROGRAM CHART

[. . . ] Only woollens, labelled with the Woolmark and identified as machine washable. 1. 0 This programme (40°C) is tested and approved by The Woolmark Company for machine washable wool. Textiles made of linen, silk, wool and viscose marked as “handwashable”. 1. 0 This programme (40°C) is tested and approved by The Woolmark Company for handwashable wool. [. . . ] *** Reference Programme for Energy Label. START DELAY The “Start delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. Do not use liquid detergent when activating the “Start delay”. • Select programme, temperature and options. • Press the “Start delay” button to select the delay time by 1 to 23 hours; • Press the “Start (Pause)” button. The countdown of the delay time begins; the “Start delay” indication lamp and the dot on the display will keep blinking until the programme starts. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • Once having pressed the “Start (Pause)” button, the number of hours preselected can be reduced by pressing again the “Start delay” button. To cancel the “Start delay” . . . before you press the “Start (Pause)” button: • Turn the programme selector to another position or press the “Reset” button. . . . after having pressed the “Start (Pause)” button: • Press the “Reset” button for at least 3 seconds - the start delay time disappears from the time display. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme and temperature. The time display shows the duration of the chosen programme (in hours and minutes), and the “Start (Pause)” indication lamp blinks. The indication lamp of the predefined spin speed lights up. SELECT ANY DESIRED OPTION Push the button(s) of any option(s) desired - the respective indication lights up. When the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. Unsuitable combinations of options are deselected automatically. “Clean+” button • Choose this option if you use an in-wash additive for stain removal (powder, for example “Vanish”) - it will optimize the additive’s efficiency to get better wash performance and stain removal. • Selectable for programmes “Cotton” and “Synthetics”; choose temperature of 30 or 40°C and use with maximum load. • Add an appropriate amount of in-wash additive for stain removal (powder) to the main wash chamber, together with your detergent (only use powder detergent with this option). Respect the manufacturer’s dosing instructions. [. . . ] The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. PROGRAMME START Open the tap and press the “Start (Pause)” button. The indication lamp of the “Start (Pause)” button lights up. The programme sequence indicator shows the current programme phase, running from left to right through Wash, Rinse, Spin/Drain. [. . . ]