User manual WHIRLPOOL AWOE 10142 S PROGRAM CHART

[. . . ] White and pastel shaded garments made of delicate fabrics. Gentle wash programme to avoid graying or yellowing of your laundry. Use heavy duty detergent, if necessary also stain removers or bleaches on oxygen basis. Black and dark garments made of cotton, cotton blends and polyester. [. . . ] Cannot be activated or deactivated when the programme selector is in the “Off/O” position. To activate the child lock: • Turn the programme selector to a programme position, or run a programme as usual. • Press and hold the 2 buttons marked with the key symbol simultaneously for a few seconds. A key symbol will appear on the display to indicate that the child lock is active. Any time you try to change a programme setting with active child lock, a signal will sound; it cannot be changed anymore. The only change possible is to switch the washer off by turning the programme selector to the “Off/O” position. To deactivate the child lock, proceed in the same way as for activating it (signal will sound twice). Consumption values were measured in normalized conditions, in compliance with IEC/EN 60456. In the home, they may vary depending on the individual water supply pressure and temperature, the load and the type of wash. The consumption data indicated are based on an inlet water temperature of approx. 15°C through the cold fill valve as well as the hot fill valve (if available). If your washing machine has a hot fill valve, connection of this valve to hot water supply will lower the energy consumption by reduced heating times, depending on the individual hot fill inlet water temperature. Water and energy consumptions refer to the default setting of the programmes, with temperature and load as indicated in the table; selecting any options or changing the spin speed will also change the consumption data. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). * ** *** Reference programmes for Energy Label. To reduce the water temperature, some cold water is added at the end of the main wash cycle before the water is drained. Automatic adaptation of programme duration after detection of wash load. SAVE YOUR FAVOURITE PROGRAMMES If there is a programme setting which you use frequently, the appliance offers the possibility to save one setting for each programme so that it can be used again by just pressing the “Favourites” key . • Select the desired programme, temperature, spin speed and option(s), press and hold the “Favourites” key for at least 3 seconds. The heart symbol on the display shortly blinks and then lights up - the programme setting is saved. Next time you want to use your individual programme setting, select the programme, shortly press the “Favourites” key and start by pressing “Start (Pause)” . If you want to replace the saved programme setting by another one: • Proceed as already described above - the previously saved programme setting will be replaced by the new one. SOUND OFF Press and hold the marked buttons simultaneously for a few seconds to switch off the peep sound of the buttons and at the end of the programme; a long signal sounds. To switch it on again, proceed in the same way; a short signal sounds twice. FAILURE INDICATORS If one of the failure indicators lights up, or in case of any malfunction, consult the “Troubleshooting Guide” in your Instructions for Use. Spin speed on display blinks: Unbalance during spinning. LOAD LAUNDRY AND SELECT PROGRAMME Load the laundry, close the door and turn the programme selector to the desired programme; the “Start/Pause” indicator blinks. [. . . ] • When you have selected the desired time until the “Cycle end”, press “Start/Pause” - the countdown will begin. • During the countdown, you can still modify the programme setting (select or deselect options, change spin speed etc. ). If the modifications prolong the programme duration so that it overruns the originally set time until the “Cycle end”, the programme will start immediately. DRUM LIGHT When you select a programme, the drum light will slowly go on to assure a good visibility during laundry loading. After starting your programme with “Start/Pause”, the drum light will fade on and off while the washing machine detects the laundry load. [. . . ]