User manual WHIRLPOOL AWOE 8040 INSTRUCTION FOR USE

[. . . ] made of cotton and linen. Fabrics Normally soiled garments made of artificial fibres (like polyester, polyacryle, viscose etc. ) or their blends with cotton. Curtains and delicate clothing, dresses, skirts, shirts and blouses. Woollens, labelled with the Woolmark and identified as machine washable, as well as textiles made of silk (keep to care label!), linen, wool and viscose marked as handwashable. This programme is tested and approved by The Woolmark Company for machine- and handwashable wool. [. . . ] • Do not use liquid detergent when activating this function. • The time until the “Cycle end” can be selected in full hour time segments (1 to 24 h). When you press the button, the shortest possible time will be displayed; keep on pressing the button to loop through all the available times. To remove it again, keep on pressing the button until you see the value “0:00”. • When you have selected the desired time until the “Cycle end”, press “Start/Pause” - the countdown will begin. • During the countdown, you can still modify the programme setting (select or deselect options, change spin speed etc. ). If the modifications prolong the programme duration so that it overruns the originally set time until the “Cycle end”, the programme will start immediately. • Sometimes the programme may finish before the selected time until the “Cycle end” has expired (e. g. In this case, the washing machine will tumble the laundry regularly to keep it fresh, until the selected “Cycle end” time has expired. During tumbling, the display will show an animation. The tumbling phase can be stopped at any time either by pressing any button or by rotating the programme selector; the animation will stop and the door will unlock in about 1 minute as indicated on the display. . PROGRAMME START Open the tap and press the “Start/Pause” button . The “Start/Pause” indicator lights up. When the laundry load is detected or the programme duration is adapted, the display shows an animation. CHILD LOCK Prevents children from starting a wash cycle or changing the settings of a running programme. Cannot be activated or deactivated when the programme selector is in the “Off/O” position. To activate the child lock: • Turn the programme selector to a programme position, or run a programme as usual. • Press the 2 buttons marked with the key symbol simultaneously for at least 3 seconds. A key-like symbol will shortly appear on the display to indicate that the child lock is active. Any time you try to change a programme setting with active child lock, the display will briefly show the key-like symbol. The programme setting cannot be changed anymore. The only change possible is to switch the washer off by turning the programme selector to the “Off/O” position. To deactivate the child lock, proceed in the same way as for activating it. Consumption values were measured in normalized conditions, in compliance with IEC/EN 60456. In the home, they may vary depending on the individual water supply pressure and temperature, the load and the type of wash. [. . . ] Press the “Start/Pause” button to pause the programme. Select the new programme, temperature, any options and another spin speed if you want. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. [. . . ]