User manual WHIRLPOOL AWOE 8100 WP PROGRAM CHART

[. . . ] Curtains and delicate clothing, dresses skirts, shirts and blouses. Only woollens, labelled with the Woolmark and identified as machine washable. This programme (40°C) is tested and approved by The Woolmark Company for machine washable wool. Textiles made of silk, linen, wool and viscose marked as “handwashable”. [. . . ] • As soon as the programme starts, the start delay on the display is replaced by the remaining programme time, and the light of the “Start delay” button goes off. • Once having pressed the “Start (Pause)” button, the number of hours preselected can be reduced by pressing and holding the “Start delay” button. From 1 hour on, the delay time can also be reduced by minutes. To cancel the “Start delay” . . before you press “Start (Pause)”: • Turn the programme selector to another position or press the “Reset/Drain” button. . . after having pressed “Start (Pause)”: • Press the “Reset/Drain” button for at least 3 seconds - the start delay time disappears from the display, or just press “Start (Pause)” to start the selected programme immediately. • Press again the 2 buttons marked with the key symbol simultaneously for at least 3 seconds. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Reset a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your Instructions for Use; if the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply; a signal sounds. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Clean pump” Waste water is not pumped out. Check whether the drain hose is kinked or the filter must be cleaned; in the latter case refer to the Instructions for Use (“Removing the Filter”). Consumption values were measured in normalized conditions in compliance with Standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The time indicated on the display can deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. *** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Load your laundry, close the door properly and add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme. The display shows the programme duration in hours and minutes as well as the predefined temperature. The “Start (Pause)” button blinks. The temperature can be altered by pressing the “Temperature” button. [. . . ] - The programme stops to “Rinse hold” when the “Rinse hold” light in the programme sequence indicator is on; the “Start (Pause)” button blinks. - To terminate the “Rinse hold” by draining the water, without any spinning, press the “Start (Pause)” button. - To terminate the programme by spinning the laundry, press the “Variable spin” button to select the desired spin speed and then the “Start (Pause)” button to start the spin cycle. PROGRAMME END • 1. The display shows “End” and the “Door open” indication lights. [. . . ]