User manual WHIRLPOOL AWOE 81200 PROGRAM CHART

[. . . ] made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Curtains and delicate clothing, dresses, skirts, shirts and blouses. Woollens, labelled with the Woolmark and identified as machine washable, as well as textiles made of silk, linen, wool and viscose marked as handwashable. This programme is tested and approved by The Woolmark Company for machine- and handwashable wool. [. . . ] • Press the Start delay button to select a delay time up to 23 hours. • Press the “Start/Pause” button . The countdown of the delay time begins; the start delay symbol and the colon between hours and minutes blink. • The time delay indication disappears when the programme starts and it is replaced by the remaining programme time. • If you use the “Dosing Aid” button: select the delay time BEFORE pressing the “Dosing Aid” button. The countdown of the selected delay time begins after having pressed the “Start/Pause” button for the second time (see separate Instructions for Use concerning the “Dosing Aid”). To cancel the “Start delay” . . . before you press the “Start/Pause” button: • Press the “Reset/Drain” button , or set the start delay time to “0:00” - the delay time disappears after a few seconds. . . . after having started the programme: - Press the “Start/Pause” button - the delay time disappears from the display. Press “Start/Pause” again if you want to start the selected programme immediately. • Press again the 2 buttons marked with the key symbol simultaneously for at least 3 seconds. FAILURE INDICATIONS If one of the failure indications on the display lights up, refer to the “Troubleshooting Guide” in your “Instructions for Use”. PROGRAMME END • 1. All the lights of the programme sequence indicator are off and the “Door open” indication lights up. Turn the programme selector to the “Off/O” position. Leave the door ajar to allow the drum to dry. DETERGENT OVERDOSAGE INDICATION The symbol will light up at the end of the programme if you used too much detergent. If the symbol lights up and the display shows “Fod”, too much foam interrupted the wash process; refer to the “Troubleshooting Guide” in your Instructions for Use. DETERGENT DOSING RECOMMENDATION With the “Dosing Aid” button, you can make your washing machine indicate you the recommended detergent quantity for your wash load, depending on the soil level selected and the size of the load. • Helps to save detergent and protect the environment and also sensitive skin by avoiding detergent overdosing. • Before you use this function, you must adapt the washing machine to the dosing amounts which are recommended for the detergents you use. Also check if your region’s water hardness corresponds with the water hardness level “soft” of your washing machine - if not adapt it. • Select programme, options and start delay BEFORE using the “Dosing Aid” button. For any details, refer to the separate “Dosing Aid” Instructions for Use. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the “Start/Pause” button to pause the programme. Select the new programme, temperature, any options and another spin speed if you want. [. . . ] - To terminate the “Rinse hold” by draining the water, without any spinning, press the “Start/Pause” button. The child lock cannot be activated or deactivated when the programme selector is in the “Off/O” position. To activate the child lock: • Turn the programme selector to a programme position, or run a programme as usual. • Press the 2 buttons marked with the key symbol simultaneously for at least 3 seconds. [. . . ]