User manual WHIRLPOOL AWOE 81200 C WP PRODUCT FICHE

[. . . ] Contact After-Sales Service or your local retailer. • Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous. • If the appliance was exposed to the cold prior to delivery, keep it at room temperature for a few hours before operating. • Water pressure (flow pressure): 100-1000 kPa (1-10 bar). [. . . ] Note: Use only specific detergents for washing wool and garments made of microfibres (like sports or swimwear). Remarks: • Any whitish residues on dark fabrics are caused by insoluble compounds used in phosphate-free powder detergents. If this occurs, shake or brush out the fabric or use liquid detergents. • Use only detergents and additives specifically produced for domestic washing machines. • When using descaling agents, dyes or bleaches for the prewash (if available on your model), make sure that they are suitable for use in domestic washing machines. Descalers could contain products which could damage your washing machine. Do not machine wash fabrics that have been treated with solvents or flammable liquids. • Do not use liquid detergent for the main wash when having activated the “prewash” option (if available on your model). • Do not use liquid detergent when activating the “Start Delay” function. Dosage Follow the dosage recommendations on the detergent pack. They depend on: • degree and type of soiling • size of wash full load: follow the detergent manufacturer’s instructions; half load: 3/4 the amount used for a full load; Minimum load (about 1 kg): 1/2 the amount used for a full load • water hardness in your area (ask for information from your water company). Soft water requires less detergent than hard water (refer to the water hardness table in the operating instructions). Clean the dispenser compartment with a damp cloth. Refit the separator and the cover grid in the dispenser drawer and push the drawer back into the dispenser compartment. GB 8 Water supply hose(s) If a supply hose shows a damage, replace it by a new hose of the same type, available through our After-Sales Service or your specialist dealer. If your supply hose has a transparent hose coating (fig. “C”), periodically check the colour of the transparent coating. If the transparent hose coating turns into an intense red, this is an indication that the hose may have a leak and should be replaced. Contact our After-Sales Service team or specialist dealer to obtain a replacement hose. A Cleaning the mesh filter in the water supply hose(s) 1. Close the tap and loosen the inlet hose on the tap. Clean the internal mesh filter and screw the water inlet hose back onto the tap. Now unscrew the inlet hose on the rear of the washing machine. Pull off the mesh filter from the washing machine connection with universal pliers and clean it. Refit the mesh filter and screw the inlet hose on again. [. . . ] • Turn the water tap on (if water immediately flows into the appliance without the appliance being started, there is a failure; turn off the tap and notify the After-Sales Service). • Select and start the desired programme again. “Overfoaming” Too much foam interrupted the wash programme. • Select and start the “Rinse & Spin” programme. [. . . ]