User manual WHIRLPOOL AWOE 9040 PRODUCT FICHE

[. . . ] jeanswear and garments made of robust jeanslike material such as trousers made of synthetic fibres; bed with 3. 0 Blanketsfibres; sleeping bags, bathmatscovers filleditems. feathers, polyester or other artificial and similar 3. 5 This programme includes a prewash cycle – you can add detergent also to the prewash chamber. Do not add any softener. Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc. Ideal be run 7. 0 Offers highest economy in energy consumption by prolonged washing duration. noise to spinning overnight to additionally profit from the more favourable energy rates. [. . . ] hours; the light of the “Start (Pause)” button • Press the “Start (Pause)” button ; the countdown of the delay time begins. The light of the “Start is on; the light of the start delay (Pause)” button button will keep blinking until the programme starts. • As soon as the programme starts, the start delay on the display is replaced by the remaining programme time, and the light of the “Start delay” button goes off. • Once having pressed the “Start (Pause)” button , the number of hours preselected can be changed by pressing and holding the “Start delay” button. To cancel the “Start delay” . . before you press “Start (Pause)” : • Turn the programme selector to another position or / . press the “Reset/Drain” button . . after having pressed “Start (Pause)” : • Press “Start (Pause)” - the delay time disappears from the display; press “Start (Pause)” again to start the selected programme immediately. • Press again the 2 buttons marked with the key symbol simultaneously for at least 3 seconds. “DOOR OPEN” INDICATION Before starting and after end of a programme, the lamp lights to show that the door can be opened. As long as a wash programme is running, the door remains locked and must on no account be forced open. In case you have an urgent need to open it during a running programme, refer to “Reset a running programme before the end”. RED INDICATIONS “Service” Lighting up of the “Service” indication can be caused by a fault in an electrical component. Refer to the “Troubleshooting Guide” in your Instructions for Use; if the fault persists, contact our After Sales Service. “Water tap closed” The appliance has no or insufficient water supply; a signal sounds. Open the water tap; if the indication still lights up, refer to the “Troubleshooting Guide” in the Instructions for Use. “Easy ironing” button • Helps to make ironing easier. • Increases the water quantity and the clothes are spun very gently. “Intensive rinse” button • More water is added and rinse cycle is prolonged. • This option is particularly suitable for areas with very soft water, washing baby linen and helping people with allergies. “Variable spin” button • Every programme has a predefined spin speed. • Press the button to set another spin speed. • If you select spin speed “0”, the final spinning is cancelled but intermediate spin peaks remain during rinse. • If you select “Rinse hold” , the laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from changing. - Select “Rinse hold” if you want to postpone spinning to a later time or if you want to drain only. - Do not leave the laundry to soak in the rinse hold for too long. - The programme stops to “Rinse hold” when the “Rinse hold” light in the programme sequence indicator is on; the “Rinse hold” light of the “Variable spin” button and the “Start (Pause)” button light blink. [. . . ] If this is the case, an animation appears on the display. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press “Start (Pause)” to pause the programme; the light blinks. Select the new programme, temperature, any options and another spin speed if you want. The light is on, and Press “Start (Pause)” the programme continues continues at the same position where the previous programme was interrupted. [. . . ]