User manual WHIRLPOOL AWOE 9202 PRODUCT FICHE

[. . . ] programme to avoid graying of heavy duty 6. 0 Gentle wash necessary also stain removersor yellowingon your laundry. Use not use liquid detergent, if or bleaches oxygen basis. Black and dark garments made of cotton, cotton blends and polyester. liquid detergent for dark garments with this programme. [. . . ] M0702 Whirlpool is a registered trademark of Whirlpool USA 5019 301 06538 Black process 45, 0° 150, 0 LPI 30106538GB. fm Page 2 Monday, September 5, 2011 3:48 PM CONSUMPTION DATA Temperature Programme (°C) Mixed Cotton Cotton* Cotton* Cotton Cotton* Synthetics Synthetics Delicates Wool/Handwash White Light colours Dark Super Silent AquaEco Speed 15 Jeans Big Items 40 95 60 60 40 40 60 40 30 40 40 40 40 60 40 30 60 40 (kg) 6. 0 7. 0 7. 0 3. 5 7. 0 3. 5 3. 5 3. 5 2. 5 2. 0 7. 0 6. 0 6. 0 7. 0 3. 0 3. 0 6. 0 3. 0 (l) 67 75** 54 43 69 46 48** 45 60 49 69 70 49 69 19 30 65 74 (kWh) 0. 58 2. 40 0. 80 0. 72 0. 72 0. 62 0. 95 0. 53 0. 40 0. 63 0. 70 0. 50 0. 60 0. 84 0. 45 0. 20 0. 55 0. 75 Load Water Energy Approx. Programme Duration (hours : minutes) without “Rapid” with “Rapid” 1:00 — 2:20 — 4:00 2:20 3:00 *** 3:00 2:05 2:45 *** 1:55 1:14 1:40 0:59 0:45 — 0:40 — 2:20 — 1:20 — 1:40 1:15 4:00 — 1:00 — 0:15 — 1:30 1:15 1:30 — • If you select “Rinse hold” , the laundry remains in the last rinse water without progressing to the final spin cycle, to avoid creasing and prevent colours from changing. To activate the “Rinse hold”, press the “Spin” button repeatedly until the “Rinse hold” symbol on the display lights up. - The wash programme stops to “Rinse hold” when the “Rinse hold” symbol on the display blinks. The light of “Start (Pause)” button blinks as well. - To terminate the “Rinse hold” by draining the water, without any spinning, press the “Start (Pause)” button. - To terminate the “Rinse hold” by spinning the laundry, press the “Spin” button to select the desired spin speed and then “Start (Pause)” to start the spin cycle. - Do not leave the laundry to soak for too long in the “Rinse hold”. PROGRAMME START Open the tap and press the “Start (Pause)” button . The blinking “Start (Pause)” button light becomes constant. The “Door open” indication goes off, and the wash symbol lights to indicate that the programme is in process. In some phases, the remaining programme time is newly calculated - if this is the case, the “6th sense” indication on the display will fade, and the remaining programme time is replaced by an animation. CHILD LOCK Activating the child lock prevents children from starting a wash cycle or changing the settings of a running programme. The programme duration may differ from the values indicated above as it depends on the operation conditions applicable at that time (see also “Troubleshooting Guide” in your Instructions for Use). * Reference programmes for Energy Label. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle before the water is drained. *** Automatic adaptation of programme duration after detection of wash load. FAILURE INDICATIONS If one of the failure indications on the display lights up, refer to the “Troubleshooting Guide” in your “Instructions for Use”. PROGRAMME END • The display shows “End”, and the “Programme finished” indication lights up. Turn the programme selector to the “Off/O” position. • Leave the door ajar to allow the drum to dry. • If you do not turn the programme selector to the “Off/O” position, all lights of the control panel go out after a few minutes to save energy - only “End” will remain on the display. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Turn the programme selector to the desired programme. The light of the “Start (Pause)” button blinks. The temperature and spin speed indicated on the display can be altered by pressing the “Temperature” button or the “Spin” button . “Prewash” button • Adds an additional prewash cycle to the wash programme selected; prolongs the programme by about a quarter of an hour. • Recommended for heavily soiled laundry (e. g. [. . . ] • Press the button to set another spin speed. • If spin speed “0” is selected, the final spinning is cancelled, and the water is drained out only. However, intermediate spin phases remain during rinse. DETERGENT DOSING RECOMMENDATION With the “Dosing Aid” button, you can make your washing machine indicate you the recommended detergent quantity for your wash load, depending on the soil level selected and the size of the load. • Helps to save detergent and protect the environment and also sensitive skin by avoiding detergent overdosing. [. . . ]