User manual WHIRLPOOL AWOS81010 PRODUCT FICHE

[. . . ] textiles made of silk , linen , wool and viscose marked as “handwashable”. This programme (40°C) is tested and approved by The Woolmark Company for handwashable wool. This cycle is particularly suitable to treat delicate lingerie (use of a laundry net strongly recommended). If you select “Rinse Hold” do not leave items to soak for too long. [. . . ] START DELAY The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. • Select programme , temperature , spin speed and options. €¢ Press the “Start Delay” button to select the delay time by 1 to 23 hours. The selected start delay is indicated on the display under “Remaining Time”. €¢ Press the “Start/Pause” button - the countdown of the selected start delay begins. €¢ The start delay indication disappears when the programme starts and is replaced by the remaining time. €¢ The number of hours can be modified later by pressing the “Start Delay” button again. To cancel the “Start Delay” • Press the "Reset" button for at least 3 seconds the start delay time disappears from the remaining time indication. PROGRAMME START Open the tap and press the “Start/Pause” button. The blue lamp under the “Start/Pause” button stops flashing and lights up. The display indicates the sequence reached in the programme by the corresponding symbol. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. When the remaining programme duration is newly calculated, the 6th sense symbol appears on the display. ** T reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. o *** Reference programme for the energy label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add the detergents as described in the programme table or in the chapter “Detergents and Additives” in your Instructions for Use booklet. Switch on the machine by pressing the “On/Off”-button. The blue indication lights of the main programmes and of the “Reset” button light up. Select the desired programme by pressing the corresponding button. The blue lamps of the other programmes go out, and the lamp of the “Start/ Pause” button flashes. The display shows the predefined spin speed and temperature corresponding to the selected programme. [. . . ] Note: The programme stops to “Rinse Hold” at the time the “Rinse Hold” symbol is indicated on the display. Fm Page 3 Friday, December 16, 2005 6:08 PM HOT / COLD FILL INSTRUCTION If you wish to connect hot and cold water supply (Fig. Fix the red marked inlet hose at the hot water tap and at the inlet valve with the red filter on the rear side of machine. Fix the other inlet hose at the cold water tap and at the inlet valve with the blue filter on the rear side of the machine. [. . . ]