User manual WHIRLPOOL AWP 092/1 INSTRUCTION FOR USE

[. . . ] Sort the laundry according to fabric type and colour and load the machine. Add detergent and any additives required. Select the programme, temperature and special options (depending on model). Press the “ON/OFF” button. 3 GB CONTENTS PAGE APPLIANCE AND ACCESSORIES PROTECTING THE ENVIRONMENT SAFETY INSTRUCTIONS MOVING AND TRANSPORTING THE APPLIANCE SORTING THE WASH DETERGENT AND ADDITIVES DYEING AND BLEACHING SELECTING THE PROGRAMME AND SPECIAL OPTIONS / PROGRAMME START DOOR LOCK / PROGRAMME END / PROGRAMME RESELECTION REMOVING THE FILTER / DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLE-SHOOTING GUIDE AFTER-SALES SERVICE INSTALLATION INSTRUCTIONS 5 6 6 6 7 8 9 PAGE PAGE PAGE PAGE PAGE PAGE PAGE 10 PAGE 10 PAGE 11 12 13 13 14 PAGE PAGE PAGE PAGE 4 APPLIANCE AND ACCESSORIES 1 3 2 4 5 6 7 8 1. [. . . ] Pour the dye colour, fixing agent and salt directly into the empty drum, and only then load the laundry. • • • Only use products designed for use in washing machines. Follow the manufacturer’s instructions. Plastic and rubber components of the machine can be stained by dyes or bleaches. 9 SELECTING THE PROGRAMME AND SPECIAL OPTIONS / PROGRAMME START SELECTING THE PROGRAMME (See also the separate programme chart and consumption data) A For appliances WITH temperature selector knob 1. Turn the programme selector knob clockwise to the desired programme. Set the temperature knob to the desired temperature. B For appliances WITHOUT temperature selector knob Turn the programme selector knob clockwise to the programme with the desired temperature. A B PRESS THE DESIRED SPECIAL OPTION BUTTON (Depending on model, see also the separate programme chart). Spin speed reduction button • Press this button to reduce the spin speed. No spin button • Press this button to exclude the spin function from the programme. Rinse hold/Spin delay button • The laundry remains in the last rinse water without being spun, to avoid heavy creasing. Remove any foreign material from the filter. Insert the filter and screw it in clockwise until it locks (until the grip is horizontal). Pour 1/2 litre of water into the detergent drawer to reactivate the Eco system. Some models have no filter, since they are fitted with a self-cleaning pump. 8 4 6 1 3 2 WHEN TO DRAIN RESIDUAL WATER • • When transporting (moving) the machine. If there is danger of freezing in the installation room. In this case the machine should be drained after every wash. DRAINING RESIDUAL WATER The residual water drain hose (if provided) is located in the machine plinth. Lift the cover upwards with light pressure. Pull out the hose by about 15 cm (6 inches). Let the water drain into a flat container until the flow stops. If your washing machine is not provided with a drain hose in the plinth, to drain the residual water please follow the instructions given in the chapter “Removing the Filter”. 11 CARE AND MAINTENANCE APPLIANCE EXTERIOR AND CONTROL PANEL • • Clean using normal household detergent (do not use abrasive products). [. . . ] If you need to add an extension, use a flexible hose of the same type and secure the union with screw-on hose clips. Maximum overall drain hose length 2. 5 m. Important: Make sure that there are no kinks in the drain hose run and take precautions against it falling while the appliance is running (Fig. 1 CONNECTION TO THE MAINS • • • Observe local utility company regulations. [. . . ]