User manual WHIRLPOOL AWSE 7010 PRODUCT FICHE

[. . . ] - Reference programme for the Energy Label. Same as the last rinse and the final spin in the “Cotton” programme. Same as the spin cycle in the “Cotton” programme. Alternative method of terminating programme after “Rinse hold”. Prewash Main Wash Softener Start delay Max Spin Speed rpm 5. 0 5. 0 5. 0 3. 0 1. 5 3. 0 3. 0 1. 0 i i i i i – – – Yes Yes Yes Yes Yes Yes Yes Yes i i i i i i i i i i i i i – – – – i i i – – – – i i i – – – – – – i i i i i i – i i – i – i – – i i – i – i – – i i i i i i i i i i i i i i i i i i i i i i i i Max. [. . . ] * Reference programmes for Energy Label. For reasons of energy saving, the real water temperature may deviate from the declared cycle temperature. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. *** Automatic adaptation of programme duration after detection of wash load • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. “Easy ironing” button • Reduces creasing by an increased water quantity and a very gentle spin. “Rinse hold” button • The laundry remains in the last rinse water without pregressing to the final spin cycle to avoid creasing and prevent colours from changing. • It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. • The programme stops to “Rinse hold” at the time the “Rinse hold” lights in the preogramme sequence indication is on. The “Start/Pause” indicator blinks. Terminate the “Rinse hold” option: • Press the “Start/Pause” button; the programme will terminate automatically with the final spin cycle for the present wash programme. • If you do not wish to spin the clothes, turn the programme selector to the “Drain” programme and press the “Start/Pause” button. . . . after having pressed the “Start/Pause” button: • Press the “Start/Pause” button - the start delay time disappears from the time display. CHANGE PROGRAMME AND/OR OPTIONS AFTER PROGRAMME START 1. Press the “Start/Pause” button to pause the programme. 2. Select the new programme, any options and another spin speed if you want. 3. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. Do not add detergent for this programme. LOAD LAUNDRY, ADD DETERGENTS AND SELECT THE PROGRAMME Load the laundry, close the door and add detergents as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. • Turn the programme selector to the desired programme and temperature. • The display shows the programme duration and the predefined spin speed. • The indication lamp next to the “Start/Pause” button blinks. If you do not start the programme soon after having made your choice, the washing machine will switch off automatically after about a quarter of an hour. To switch the washing machine on again, turn the programme selector to “Off/O” and afterwards to the desired programme again. SELECT ANY DESIRED OPTION Push the button of any option desired - the respective indication lamp lights up. If the combination of programme and additional option(s) is not possible, the indication lights switch off automatically. [. . . ] Respect the manufacturer’s dosing instructions. • May prolong the programme by up to 15 minutes • Appropriate for use of stain removers and bleaches on oxygen basis. Chlorine or perborate bleaches must not be used!“Cold wash” button • Saves energy used for water heating while maintaining good wash result. [. . . ]