User manual WHIRLPOOL AWT 2458 PROGRAM CHART

[. . . ] The maximum load for heavily soiled washing is 3. 5 kg. Normally soiled bed linen, table linen and underwear, towels, shirts etc. Slightly to normally soiled bed linen, table linen and underwear, towels, shirts etc. , made of cotton and linen. Slightly soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton. [. . . ] * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. ** To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. “Rinse Hold” button • The laundry remains in the last rinse water, without progressing to the spin cycle to avoid creasing and prevent colours from changing. • This option is especially recommended for the “Synthetics” or “Delicate” programmes. • This option is perfectly suitable if you wish to postpone the spin or you don't wish to spin the clothes. Note: the programme selector stops on “ Terminate the “Rinse Hold” option. • Press the “Rinse Hold” button again; the programme will terminate automatically with the spin cycle corresponding to the previously selected wash programme. • If you do not wish to spin the clothes, switch off the appliance by pressing the “On/Off” button . Turn the programme selector to the “Drain” position and switch on the appliance. PROGRAMME START Open the water inlet tap and press the “On/Off” button . DOOR LOCK During the running programme, the door cannot be opened. The door locks automatically in all programmes. If the programme is stopped or if an electrical power failure occurs, the door unlocks automatically after about 1 minute. PROGRAMME END • The programme selector knob is at “STOP”, the pilot lamp lights. Cancel the options by pressing the appropriate buttons. Wait for the door to unlock (about 1 minute). Open the door and the drum flaps and unload the machine. SELECTING A NEW PROGRAMME, SPIN SPEED, OPTIONS AFTER PROGRAMME START 1. Press the “On/Off” button to switch off the appliance. Select the new programme, temperature and options. Press the “On/Off” button to switch on the appliance. TO STOP RESET A PROGRAMME , BEFORE THE END 1. [. . . ] Note: with the “Cotton” and “Synthetics” programmes a short spin cycle is provided in any case, even if the exclusion has been selected, in order to optimize rinsing results. “Intensive Rinse” button • The water level increases for improved rinsing efficiency. • This option is particularly suitable for areas with very soft water when washing baby linen and helps people with skin allergies. • For improved garment care it is advised to use the option for the Cotton 90° C and the Coloured 60° C programme. 3. [. . . ]