User manual WHIRLPOOL AWT 3310 PROGRAM CHART

[. . . ] Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. Normally soiled bed linen, table linen and underwear, towels, shirts etc. , made of cotton and linen. Slightly to normally soiled textiles made of cotton and/or synthetics. Normally to heavily soiled blouses, shirts, overalls etc. [. . . ] Please avoid excessive detergent dosing. Whirlpool is a registered trademark of Whirlpool USA 5019 312 10406 CONSUMPTION DATA Programme Cotton Cotton Cotton Daily Mixed 60’ Synthetics Synthetics Delicate Wool Silk Temperature Selector (°C) 95 60 40 40 60 40 40 40 30 Load (kg) 5. 0 5. 0 5. 0 3. 0 2. 0 2. 0 1. 5 1. 0 1. 0 Water (l) 63* 55 55 49 56 50 60 60 60 Energy (kWh) 1. 85 0. 95 0. 55 0. 48 0. 80 0. 45 0. 60 0. 50 0. 30 Approx. Programme Duration (hours : minutes) 2:05 2:05 2:05 1:00 1:30 1:20 0:45 0:40 0:50 Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy Label” refer to the programme “Cotton 60°C”. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. “Rinse Hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading. • This option is particularly recommended for the “Synthetics”, “Delicate” and “Daily Mixed 60’” programmes. • This function is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. Note: the programme selector knob stops on . Appliance in “Rinse Hold”: • Press the “Rinse Hold” button again: the programme will terminate automatically with the selected spin cycle. • If you do not wish to spin the clothes, press the “On/Off” button, turn the programme selector knob to the “Drain” programme and press the “On/Off” button again. PROGRAMME START Turn on the tap and press the “On/Off” button. The indicator light of the “On/Off” button lights up. Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. END OF WASH CYCLE • The programme selector knob is in the Stop position. Press the “On/Off” button to switch off the machine. Wait for the lid to unlock (about 1 minute). Open the lid and the drum doors and unload the machine. Leave the lid open for some time to allow the inside of the appliance to dry. CHANGE THE PROGRAMME DURING THE WASH CYCLE 1. Switch off the machine by pressing the “On/Off” button. [. . . ] If the spin speed “ ” is selected, the final spin is cancelled. The programme ends with a drain cycle. SELECT THE DESIRED OPTION Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. “Rapid” button • For fast, energy saving wash cycles. [. . . ]