User manual WHIRLPOOL AWT 3385 PROGRAM CHART

[. . . ] Normally to heavily soiled bed linen, table linen and underwear, towels, shirts etc. Normally soiled bed linen, table linen and underwear, towels, shirts etc. , made of cotton and linen. Slightly to normally soiled textiles made of cotton and/or synthetics. Normally to heavily soiled blouses, shirts, overalls etc. [. . . ] 30 850 700 2) 700 2) 850 850 850 700 2) 700 2) 700 2) 700 2) Yes 1) Yes 1) — — — — — — — — — — — — — Synthetics Synthetic short Delicate Wool Silk Rinse & Gentle Spin Rinse & Spin Spin Gentle spin Drain — 3) 700 2) 850 850 700 2) — — — — — — — — — — — — — — — — — N. B. Please avoid excessive detergent dosing. Whirlpool is a registered trademark of Whirlpool USA 5019 312 10405 CONSUMPTION DATA Programme Cotton Cotton Cotton Daily Mixed 60’ Synthetic Synthetic Delicate Wool Silk Temperature Selector (°C) 95 60 40 40 60 40 40 40 30 Load (kg) 5. 0 5. 0 5. 0 3. 0 2. 0 2. 0 1. 5 1. 0 1. 0 Water (l) 63* 55 55 49 56 50 60 60 60 Energy (kWh) 1. 85 0. 95 0. 55 0. 48 0. 80 0. 45 0. 60 0. 50 0. 30 Approx. Programme Duration (hours : minutes) 2:05 2:05 2:05 1:00 1:30 1:20 0:45 0:40 0:50 “Intensive Rinse” button • The amount of water is increased to ensure a more intensive rinse. • This option is particularly suitable for areas with very soft water or washing linen laundry for people with skin allergies. PROGRAMME START Turn on the tap and press the “On/Off” button. The indicator light of the “On/Off” button lights up. Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. END OF WASH CYCLE • The programme selector knob is in the Stop position. Press the “On/Off” button to switch off the machine. Wait for the lid to unlock (about 1 minute). Open the lid and the drum doors and unload the machine. Leave the lid open for some time to allow the inside of the appliance to dry. CHANGE THE PROGRAMME DURING THE WASH CYCLE 1. Switch off the machine by pressing the “On/Off” button. Start programme by pressing the “On/Off” button again. PAUSE/INTERRUPT A PROGRAMME If, for any reason, you wish to interrupt the programme for a certain time and continue it later: 1. After the desired pause, press again the “On/Off” button. CANCEL PROGRAMME 1. Switch off the machine by pressing the “On/Off” button. [. . . ] Turn the spin speed selector knob to the desired spin speed. If the spin speed “ ” is selected, the final spin is cancelled. The programme ends with a drain cycle. SELECT THE DESIRED OPTION Selecting or deselecting an option can be done at any time during the programme. The option will be applied as long as the corresponding programme phase has not been executed yet. [. . . ]