User manual WHIRLPOOL AWT 4097 PROGRAM CHART

[. . . ] Rinse Intensive Speed Hold Rinse °C rpm/min rpm/min min 2) Cotton with prewash Cotton Heavily soiled, hard wearing and temperature stable textiles in cotton and linen (bed linen, table linen, underwear, shirts etc. ). load for heavily soiled laundry is 3, 5 kg. Averagely soiled, hard wearing and temperature stable textiles in cotton and linen (bed linen, table linen, underwear, shirts etc. ). 4. 5 Yes Yes ❉ ❉ ❉ — ❉ ❉ ❉ — — — — — — — — — ❉ ❉ ❉ ❉ ❉ ❉ — — — — — — ❉ ❉ ❉ ❉ ❉ ❉ — ❉ ❉ ❉ ❉ ❉ — — — — — — — to 90 Max. * Max. 130 4. 5 Yes Yes to 90 Max. * Max. 115 Mixed Cotton/ Lightly soiled textiles in cotton or linen blouses, shirts, dark coloured terry cloth, coloured linen articles, jeans, etc. [. . . ] The excess of detergent in the dispenser could cause technical problems. 5019 100 12570 GB CONSUMPTION DATA Programme Temperature Selector (°C) 90 60 60 40 40 30 40 40 Load (kg) 4. 5 4. 5 2. 0 2. 0 2. 5 1. 5 1. 5 1. 0 Water (l) 72 59 66 54 49 45 70 70 Energy (kWh) 1. 8 1. 15 0. 8 0. 4 0. 5 0. 3 0. 65 0. 55 Programme Duration (min) 115 115 100 100 85 70 55 45 • • • • Especially suitable for lightly soiled or small loads (reduce the detergent quantity). ” The laundry remains in the last rinse water without progressing to the spin cycle to avoid creasing and prevent colours from changing. This option is particularly recommended for the programmes Synthetic “ ” or Delicate “ ”. This function is particularly useful if you want to postpone spinning to a later time or when you do not wish to spin the clothes. Rinse Hold button “ Cotton + Intensive Rinse Cotton Mixed + Intensive Rinse Mixed Rapid + Half Load Synthetic + Half Load Delicate Wool Note: The programme selector knob stops on the position “ Terminate the Rinse Hold option: • Press the Rinse Hold button again; the programme will terminate automatically with the spin cycle for the preset wash programme. • If you do not wish to spin the clothes, turn the programme knob to the drain programme “ ” and push the On/Off button “ ”. Intensive Rinse button “ • • ” The water level increases for improved rinsing efficiency. This option is particularly suitable for areas with very soft water when washing baby linen and helps people with allergies. Prewash cycle increases programme duration by approx. Consumption values were measured in normalized conditions in compliance with Standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. ADDING DETERGENT AND ADDITIVES Add the detergent and the additives into the dispenser as follows: • • Programmes with pre- and main wash Main wash programme without prewash PROGRAMME START Open the tap and press the On/Off button “ ”. The pilot lamp lights up. • Fabric softeners and conditioners • Stain remover agents • Anti-scale agents (water hardness 4) Important: • Be careful not to fill more than the “MAX” level mark. • For programmes with prewash: do not use liquid detergents. • For programmes without prewash from cold to 40° C it is recommended to use a liquid detergent to avoid whitish residues on the coloured laundry. DOOR LOCK During the running programme the door cannot be opened. The door locks automatically in all programmes. If the programme is stopped or the electrical power supply is terminated, the door lock will open after approximately 1 minute. PROGRAMME END • 1. The programme selector knob is at “Stop”. Press the On/Off button “ ”. [. . . ] Half Load button “ ” • Reduces water consumption in the cottons and easy care programmes, above all during the prewash and the rinse. TO STOP, RESET A PROGRAMME BEFORE THE END 1. Press the On/Off button “ ” to switch off the appliance. Set the programme selector to drain “ ”. [. . . ]