User manual WHIRLPOOL AWT 5108 PROGRAM CHART

[. . . ] Slightly to normally soiled blouses, shirts, overalls etc. made of polyester (Diolen, Trevira), polyamide (Perlon, Nylon) or blends with cotton. Slightly soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton. [. . . ] Alternative method of terminating programme after “Rinse Hold”. 5. 0 2. 0 1. 5 5. 0 3. 0 2. 0 1. 5 1. 5 1. 0 1. 0 2. 0 5. 0 5. 0 2. 0 Yes Yes 1) 1) Yes Yes Yes Yes Yes Yes Yes Yes Yes Yes h h h h h h h h h h h h — — — h h — h h h h — — — — — — — — h h h h h h h h h h h h — — — Max. 30 1000 800 2) 800 2) Yes 1) — — — — — — — — — — — — 1000 1000 800 800 800 800 2) 2) 2) 2) — 800 3) — — — — — — — — — — — — — — — 2) 1000 1000 800 2) — — N. B. This machine is controlled by sensors. Please avoid excessive detergent dosing. Whirlpool is a registered trademark of Whirlpool USA. 5019 312 00066 CONSUMPTION DATA Temperature Selector Programme (°C) Cotton Cotton Cotton Synthetic Synthetic Delicate Wool Silk 95 60 40 60 40 40 40 30 (kg) 5. 0 5. 0 5. 0 2. 0 2. 0 1. 5 1. 0 1. 0 (l) 63* 55 55 56 50 60 60 60 (kWh) 1. 80 0. 95 0. 55 0. 80 0. 40 0. 55 0. 50 0. 30 Load Water Energy Approx. Programme Duration (hours : minutes) 2:05 2:05 2:05 1:35 1:30 0:50 0:40 0:50 PROGRAMME START Turn on the tap and press the “On/Off” button. The indicator light of the “On/Off” button lights up. Note: If there is a power interruption or if the appliance is disconnected during the cycle, the programme will run again from the point where it was interrupted. END OF WASH CYCLE • The programme selector knob is in the Stop position “ ”. Press the “On/Off” button to switch off the machine. Wait for the door to unlock (about 1 minute). Open the door and the drum flaps and unload the machine. CHANGE THE PROGRAMME DURING THE WASH CYCLE 1. Switch off the machine by pressing the “On/Off” button. Start programme by pressing the “On/Off” button again. PAUSE/INTERRUPT A PROGRAMME If, for any reason, you wish to interrupt the programme for a certain time and continue it later: 1. After the desired pause, press again the “On/Off” button. Switch off the machine by pressing the “On/Off” button. Set the programme selector to “Drain”. Press the “On/Off” button again to start the “Drain” programme. Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. [. . . ] The option will be applied as long as the corresponding programme phase has not been executed yet. “Half Load” button • Can be used for small loads and lightly soiled laundry. • Reduces the water consumption especially during the rinses. “Rinse Hold” button • The laundry remains in the last rinse water without progressing to the final spin cycle to avoid creasing and prevent colours from fading. [. . . ]