User manual WHIRLPOOL AWT 8085 PROGRAM CHART

[. . . ] Slightly soiled overalls and sportswear made of cotton, polyester, polyamide and blends with cotton. Curtains and delicate clothing, dresses, skirts, shirts and blouses. Textiles made of silk, linen, wool and viscose marked as “handwashable”. If you select “Rinse Hold” do not leave items to soak for too long. [. . . ] The programme ends with a drain cycle. DOOR LOCK For safety reasons, the door is locked during certain phases of the cycle. At the end of the cycle or during an interruption, the door unlocks automatically after about 1 minute. END OF WASH CYCLE • The remaining time is on “0: 00” and the “End” lamp lights up. Turn the programme selector to the “ ” position. Open the door and the drum flaps and unload the machine. START DELAY The “Start Delay” button allows the user to run the machine at his convenience, for example at night when electricity is cheaper. • Select programme, temperature and options. • Press the “Start Delay” button several times to select the delay time by 1 to 19 hours; • Press the “Start/Pause” button. The indicator light of the “Start/Pause” button lights up and the lamp of the “Start Delay” button flashes. • The time delay indication disappears when the programme starts and is replaced by the remaining time. • The number of hours preselected can be reduced later by pressing the “Start Delay” button again. To cancel the “Start Delay” option • Turn the programme selector to the “ ” position. • Reselect the desired programme and options and press the “Start/Pause” button. CHANGE THE PROGRAMME OR OPTIONS DURING THE CYCLE 1. Select the new programme using the programme selector. If necessary, select the additional options and the spin speed. The luminous indicator of the “Start/Pause” button flashes. Note: the “Start Delay” and “Prewash” options cannot be selected after a programme change. Press the “Start/Pause” button. The new programme selected continues at the same position where the previous programme was interrupted. Note: Do not add detergent for this programme. Prewash cycle increases programme duration approximately 15 min. Consumption values were measured in normalized conditions in compliance with standard IEC 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. The data on the “Energy Label” refer to the programme “Coloured Cotton 60°C”. * The remaining time indicator can similarly deviate from the values in the table, because it takes into account the household conditions applicable at that time. [. . . ] Note: The programme stops to “Rinse Hold” when the “Rinse Hold” light indicator programme is on during the cycle. PAUSE/INTERRUPT A PROGRAMME If, for any reason, you wish to interrupt the programme for a certain time and continue it later: 1. Press the “Start/Pause” button. After the desired pause, press again on the “Start/Pause” button. PROGRAMME START Turn on the tap and press the “Start/Pause” button. The indicator light of the “Start/Pause” button lights up. [. . . ]