User manual WHIRLPOOL AWT 9080/1 PROGRAM CHART

[. . . ] made of cotton, coloured cotton and linen. For temperature selection, please respect the manufacturer's recommendation on the care label. At a temperature of 80°C or more, this programme eliminates bacteria, ensuring sanitization of your laundry. The bacteria removal efficiency has been tested following a similar methodology to the NF EN 13697 standard of Nov. [. . . ] *** Reference Programme for Energy Label. Prewash cycle might increase programme duration. Consumption values were measured in normalized conditions in compliance with standard IEC/EN 60 456. Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. Note: The programme with “Rinse Hold” stops when the “Rinse Hold” is indicated in the display. Appliance in “Rinse Hold”: • If you want to continue the programme press the “Start/Pause” button again: The programme will terminate automatically with the selected spin cycle. If the load is dry then please press the “Start/Pause” button. • If you do not wish to spin the load, turn the programme selector knob to the “Drain” programme and press the “Start/Pause” button. “Spin Speed Reduction” button • Every programme has an automatically allocated maximum spin speed. • Press the button until you have reached the requested spin speed indicated in the display. • If the spin speed “0” is selected, the final spin is cancelled, but not the intermediate spins. START DELAY The “Start Delay” button allows the user to run the appliance at his convenience, for example at night when electricity is cheaper. • Select programme, temperature and options. • Press the “Start Delay” button several times to select the delay time by 1 to 24 hours (selected delay is indicated in display); • Press the “Start/Pause” button. The indicator light of the “Start/Pause” button lights up, the lamp of the “Start Delay” button flashes and the selected delay is indicated in the display. • The time delay indication disappears when the programme starts and is replaced by the remaining time. • The number of hours preselected can be reduced later by pressing the “Start Delay” button again. To cancel the pre-selected “Start Delay” • Turn the programme selector to the “ ” position. • Reselect the desired programme and options and press the “Start/Pause” button. PROGRAMME START Open the tap and press the “Start/Pause” button. The indicator light of the “Start/Pause” button lights up. At programme start the sequences reached by the programme are indicated in the display. Note: If there's a power cut during the cycle, the programme will continue automatically from where it was interrupted. LID LOCK For safety reasons, the lid is locked during certain phases of the cycle. At the end of the cycle or during an interruption, the lid unlocks automatically after about 1 minute. [. . . ] SELECT THE DESIRED OPTION When you select an option authorized by the programme, the corresponding indicator lights up, except if the combination of programme, additional options and temperature is not possible. “Easy Ironing” button • Can be used together with “Cotton”, “Synthetics” and “Daily Mixed” programmes to make ironing easier. • Increases the water quantity in rinsing and the clothes are spun in a softer manner. “Eco plus” button • With a modified temperature profile and a slightly prolonged washing duration, the optimum combination of excellent washing result and even lower energy consumption can be achieved. “Prewash” button • Only for heavily soiled loads (for example mud, granular dirt). [. . . ]