User manual WHIRLPOOL AWV 413/2 INSTRUCTION FOR USE

[. . . ] • Keep the packaging materials (plastic bags, polystyrene parts, etc. ) out of reach of children, as they are potentially dangerous. 6. Electrical connections • Electrical connections must be carried out by a qualified technician in compliance with the manufacturer’s instructions and current standard safety regulations. • Voltage information, power consumption and electrical protection data are supplied on the inside of the appliance door. • The appliance must be connected to the mains exclusively by means of a socket with an earth connection in accordance with established regulations. The manufacturer declines all liability for damage to property or injury to persons or animals deriving either directly or indirectly from failure to observe the directions. [. . . ] Traditional way: • Add bleach into the bleach dispenser chamber . • Add detergent in the main wash dispenser chamber . • Select a programme and temperature and start the machine. • The machine will automatically deliver both products to the laundry at the appropriate time, the detergent is added in the main wash, the bleach is added during the second cold rinse. 22 5gb10028. fm5 Page 23 Wednesday, June 26, 2002 5:24 PM 2. Pre-bleach method: Laundry with heavy stains may be PRE-BLEACHED in the machine prior to carrying out a normal wash programme. Proceed by diluting the bleach in approximately 1l water outside of the washing machine in a small container. For a machine with temperature selector: • Turn the programme selector to programme 4. • Turn the temperature selector to Min. Warning: Bleaching is only possible in a cold wash, otherwise your laundry and your appliance will be damaged. For a machine without temperature selector: • Turn the programme selector to programme 5. • Press the special option button “cold wash” (if available). Warning: Bleaching is only possible in a cold wash, otherwise your laundry and your appliance will be damaged. Poor the diluted bleach into chamber and start the machine. • Remove the filter if the pump is blocked by an object (buttons, coins, safety pins, etc. ). IMPORTANT: Make sure the water has had time to cool before draining the appliance. 2 6 4 DRAINING RESIDUAL WATER 1. Unclip the drain hose connection on the rear part of the machine (see arrow A and B). Place a container in suitable size beside the machine. Note: After a correct draining cycle the residual water amounts about up to 1 litre but there can be up to 20 litres of water in the machine if stopped during a programme and even 40 litres if the pump is blocked. Lower the drain hose into a container and let the water drain. Note: Make sure that the water has cooled before draining. Fix again the drain hose on the rear side of the machine (see arrow B) otherwise there is the risk of leakage and the normal filling and draining functions of the machine cannot be guaranteed. Replace the drain hose with the “U” bend and fix it. • Before transporting (moving) the machine. • If the appliance is installed in a room subject to sub-zero temperatures. [. . . ] Make sure there are no kinks in the hose. Check water-tightness of tap and appliance connections by turning the tap completely on. If the hose is too short, replace it with a suitable length of pressure resistant hose (1000 kPa min, EN 50084 approved type). Periodically check the hose for brittleness and cracks and replace if necessary. [. . . ]