User manual WHIRLPOOL AWV 600 INSTRUCTION FOR USE

[. . . ] 50110084GB. fm Page 18 Wednesday, September 7, 2005 6:51 PM CONTENTS BEFORE USING THE WASHING MACHINE FIRST WASH CYCLE PRECAUTIONS AND GENERAL RECOMMENDATIONS DESCRIPTION OF THE WASHING MACHINE PREPARATION OF THE WASHING DETERGENTS AND ADDITIVES LIQUID BLEACH (HYPOCHLORITE) DYEING WASHING PROGRAMME REMOVING THE FILTER DRAINING RESIDUAL WATER CARE AND MAINTENANCE TROUBLESHOOTING GUIDE AFTER-SALES SERVICE TRANSPORT AND HANDLING INSTALLATION ELECTRICAL CONNECTION 50110084GB. fm Page 19 Wednesday, September 7, 2005 6:51 PM BEFORE USING THE WASHING MACHINE 1. Removing the packaging and check • After unpacking, make sure that the washing machine is undamaged. If in doubt, do not use the washing machine. Contact After-Sales Service or your local retailer. [. . . ] The indicator light will come on (if it is present - depending on the model). Door lock The door locks automatically after the programme start until the end of the programme. If the programme selector is moved to the “Stop” position or if the electricity supply is interrupted, then after approximately one minute the door is released. In case of interrupted electricity do not open the door, because hot water could be released from the appliance. Programme end The programme selector knob is at the stop position. Cancel the special options by pressing the appropriate buttons. Wait for the door to unlock (about one minute). Do not fully close the door but leave it ajar to allow the drum to dry out. Changing programme 1. For this programme do not add any further detergent. Changing options The options can be selected or deselected without switching off the appliance. Programme interruption or pause To interrupt the running programme for a certain period and continue it at a later time: 1. Following the desired pause press the “On/Off” button once again. Cancelling the programme If the current programme is to be terminated prematurely and cancelled, the water must be pumped out first before the door can be opened: 1. Press the “On/Off” button to switch off the appliance. Set the programme selector to programme setting “Drain”. Press the “On/Off” button in order to start the “Drain” programme. 25 50110084GB. fm Page 26 Wednesday, September 7, 2005 6:51 PM REMOVING THE FILTER 1. Switch off the appliance and drain the water (see next paragraph “Draining residual water”). Place a tray or container beneath the cover. Slowly turn the filter anticlockwise without unscrewing it completely (using pliers to handle the filter grip makes screwing easier). Wait until all the water has drained off. Now unscrew the filter completely and remove it. Remove any foreign material from the filter. Insert the filter and screw it in clockwise firmly until it locks. Pour 1/2 litre of water into the detergent drawer and check that water does not leak from the filter. Check the filter two or three times a year and clean it if necessary. • Check the filter if the appliance is not draining properly or if it fails to perform spin cycles. [. . . ] Screw the threaded connector with the filter inserted onto the tap. Check water-tightness of tap and appliance connections by turning the tap completely on. If the hose is too short, replace it with a 3 m Water Stop hose (available from After-Sales Service or from your dealer). This operation must be carried out exclusively by a licensed electrician. [. . . ]