User manual WHIRLPOOL AWV 616 INSTRUCTION FOR USE

[. . . ] Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. Shortly worn outer clothing made of cotton, polyester, polyamide and blends with cotton. Only woollens with a felt-free finish, labelled with the woolmark and identified as machine washable. Textiles made of linen, silk, wool and viscose marked as “handwashable”. [. . . ] Consumption data in the home may vary with respect to the values in the table in relation to the water supply pressure and temperature, the load and the type of wash. * To reduce the water temperature, some cold water is added at the end of the main wash cycle, before the pump drains the water out. ** Reference Programme for Energy Label. ADD DETERGENTS, CLOSE THE DOOR AND SELECT THE PROGRAMME Add detergent as indicated on the front page and as described in the chapter “Detergent and Additives” in your Instructions for Use. Close the door and turn the programme selector to the desired programme and temperature. The indication lamp next to the “Start/Pause” button blinks and the indication lamp of the predefined spin speed lights up. SELECT ANY DESIRED OPTION “Intensive rinse” button • More water is added and rinse cycle is prolonged. • This option is particularly suitable for areas with very soft water, washing baby linen and helps people with allergies. “Rinse hold” button • The laundry remains in the last rinse water without pregressing to the final spin cycle to avoid creasing and prevent colours from changing. • This option is particularly recommended for the programmes “Synthetics”, “Daily load” and “Delicates”. • It is particularly useful if you want to postpone spinning to a later time, or if you want to drain only. • If you select “Rinse hold” do not leave items to soak for too long. Note: The programme stops to “Rinse hold” at the time the “Rinse hold” lights in the preogramme sequence indication is on. The indication lamp next to the “Start/Pause” button flashes. Terminate the “Rinse hold” option: • Press the “Start/Pause” button; the programme will terminate automatically with the final spin cycle for the present wash programme. • If you do not wish to spin the clothes, turn the programme selector knob to the “Drain” programme and press the “Start/Pause” button. The “Start Delay” allows to run the machine at the consumer’s convenience, for example at night when electricity is cheaper. Do not use liquid detergent when activating “Start delay” option. • Select programme, temperature and options. • Press the “Start Delay” button to select the delay time by 1, 3, 6, 9 or 12 hours. • Press the “Start/Pause” button. The indication over to the “Start Delay” button lights up and goes off when the programme starts. • Once having pressed the “Start/Pause” button, the countdown of the time delay begins. When the programme starts, the start delay indicator light goes off and is replaced by the programme sequence indication. • After the “Start/Pause” button has been pressed, the number of hours preselected can be reduced by pressing again the “Start Delay” button. [. . . ] Press the “Start/Pause” button to pause the programme. Select the new programme (with temperature), any options and another spin speed if you want. Press the “Start/Pause” button again. The new programme continues at the same position where the previous programme was interrupted. [. . . ]