User manual WHIRLPOOL AWZ 220 INSTRUCTION FOR USE

[. . . ] • Mains cable replacement is only to be carried out by After-Sales Service. • After installation access to the mains plug has to be guaranteed, or the all-pole disconnection has to be possible with a switch. Installation • Do not install your dryer where it can be subject to extreme conditions, such as: poor ventilation, temperatures around freezing or above 35° C. Before running the first cycle ensure the water container and heat exchanger are correctly positioned. [. . . ] • To clean the outside of the dryer, use a neutral detergent and a damp cloth. • Wipe away lint from the door seal and the door using a damp cloth. • If the lint filter mesh is clogged, clean it with water and a soft brush. • Since lint can go through the filter it is necessary to clean, from time to time, the complete filter area (including below the filter) with a brush, a damp cloth or with a vacuum cleaner. • If necessary, the power cable may be replaced with an identical one obtained from our After-Sales Service. The power cable must only be replaced by a qualified technician. • EC Declaration of Conformity This dryer has been designed, constructed and distributed in compliance with the safety requirements of EC Directives: • 73/23/EEC Low Voltage Directive • 89/336/EEC EMC Directive • 93/68/EEC CE Marking Directive. The packing box may be fully recycled as confirmed by the recycling symbol . Energy saving tips • Always dry a full load: depending on the type of laundry and the programme/drying time. • By preference use the maximum spin speed allowed by your washing machine, since draining the water mechanically requires less energy. You will save time and energy when running your drying cycle. • Clean the lint filter after every drying cycle. Avoid bending and twisting the hose. B C 8 DOOR REVERSIBILITY / CHILD SAFETY LOCK Door Reversibility A. Using a spanner, turn the contact pin in the upper part of the door by 90° and remove it. C D. Unscrew the 2 screws of the door hinge and remove the door. Removing the door lock: Unscrew the 2 screws above and below the door lock system. Lift the door lock from the bottom, sliding it upwards about 1. 5 cm, and remove it. Reverse the door: Fasten the door on the desired side with the 2 screws. Insert the door lock system on the opposite side of the hinge fixation and push it down 1. 5 cm. Fix the 2 screws above and below the door lock system. Take care not to reverse the sense of the door lock system. The child safety must be above the locking mechanism. Replace the contact pin in the inside of the door (top). C D Child Safety Lock How to use the child safety lock 1. [. . . ] The dryer does not operate: (after a power failure and/or interruption to the mains supply, always press the Start/Pause button). • Is the plug properly inserted into the mains electricity socket?• Has the start delay option been selected?• Has the Start/Pause button been pressed? [. . . ]